Hitachi GR2000 Series manual Bgp4+ invalid hold time value at ’Value’ not

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-5 Routing Protocol Error Messages (continued)

bgp4+: external peer must not have the same	The AS number of a local router was specified using the peer AS
AS as we do locally (<As>)	number of an external peer. Do not specify the AS number of a local
	router in the peer AS number of an external peer.
	<As>: AS number of local router
bgp4+: external peer must not have the same	The member AS number of a local router was specified using the
AS as we do locally member AS (<As>)	peer AS number of an external peer. Do not specify the member AS
	number of a local router in the peer AS number of an external peer.
	<As>: Member AS number of local router
bgp4+: gateway <IPv6 Prefix> is not global/	Specified gateway is invalid. Specify the global address, site-local
site-local/linklocal IPv6 address	address or linklocal address.
	<IPv6 Prefix>: Specified gateway address
bgp4+: gateway not a host address on an	The specified gateway is not a host address in the connected
attached network:<IPv6 Prefix>	network. Define the gateway address in the defined interface
	address.
	<IPv6 Prefix>: Specified gateway address
bgp4+: Invalid address specified at lcladdr	The interface of the specified interface address cannot be found.
option	Specify the defined interface address.
bgp4+: invalid as_count value at ’<Value>’	The range of the Ascount value is specified incorrectly.
not in range 1 to 25	Specify in the range of 1 to 25.
	<Value>: Specified ascount value
bgp4+: invalid BGP4+ localpref value at	Specified LOCALPREF value is invalid. Specify value within the
’<Metric>’ not in range 0 to 65535	range of 0 to 65535.
	<Metric>: Specified LOCALPREF value
bgp4+: invalid BGP4+ metric value at	BGP metric value is invalid in BGP4+. Specify value within the range
’<Metric>’ not in range 0 to 4294967295	of 0 to 4294967295.
	<Metric>: Specified metric value
bgp4+:invalid community id value at ’<Value>’	In the comm-split parameter, the range of Comm_id value is invalid.
not in range 0 to 65535	Specify a value within the range of 0 to 65535.
	<Value>: Specified Comm_id value
bgp4+: invalid hold time value at ’<Value>’ not	Hold time value is invalid. Specify value within the range of 3 to
in range 0 to 65535	65535 or 0.
	<Value>: Specified ascount value
bgp4+: invalid policy group number value at	Policy group number is invalid. Specify a value within the range of 1
<Group Number> not in range 1 to 16	to 16.
	<Group Number>: Specified masl length
bgp4+: invalid preference value at ’<Value>’	Preference value is invalid. Specify value within the range of 2 to
not in range 2 to 255	255.
	<Value>: Specified preference value
bgp4+: local-as may only be used with	The Local-as option is defined for other than external peers. This
external peers	option may only be used for external peers.
bgp4+: member-as must be different	The AS number to which this device belongs is the same as the
autonomous-system	member AS number. Specify the AS number with a different number
	from the member AS number.
bgp4+: metric-out option is not supported the	A Metricout option is specified in the policy group. Specify a
policy group	Metricout option on the Export filter side.
bgp4+: multipath-option (all-as) must be set	For the all-as parameter of multipath-option, the all-as parameter of
compare-med (all-as)	compare-med must be set. Specify the all-as parameter of
	compare-med when specifying the all-as parameter of
	multipath-option.
bgp4+: Number of local-as is more than	The number of defined local-as options exceeds the maximum
maximum permitted(16)	allowable value. Define local-as options of less than maximum 16.
bgp4+: Only External groups may be	The confederation parameter is specified by the internal peer. Do not
Confederation Peer	specify the confederation parameter by using the internal peer.

5-28	GR2K-GA-0014
	Ver. 07-02