Hitachi GR2000 Series manual Shorter than prefix mask Mask2

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-5 Routing Protocol Error Messages (continued)

network-filter: invalid {inetIPv6} mask bits	At masklen/prefixlen. the mask length is valid. Specify value within
value at <Masklen> not in range 0 to {32128}	the range of 0 to 32/128.
	<Masklen>: Specified mask length
network-filter: invalid low end of range value	In the between specification, lower limit value of mask range is
at <Value> not in range 0 to {32128}	invalid. Specify a value within the range of 0 to 32/128.
	<Value>: Lower limit of specified mask range
network-filter: invalid network-filter number	ID number is out of valid range. Specify value within the range of 1 to
value at <Value> not in range 1 to 65535.	65535.
	<Value>: Specified ID number
network-filter: invalid octet value at <Value>	More than 255 values are defined in dot notation. Specify value
not in range 0 to 255	within the range of 0 to 255.
	<Value>: Specified value
network-filter: IPv6 prefix cannot be linklocal	The link local address is specified in the network address. Do not
in configuration	use the link local address.
network-filter: IPv6 prefix cannot be multicast	The multicast address is specified in the network address. Do not
in configuration	use the multicast address.
network-filter: linklocal address should be	An interface name is not specified in the specified link local address.
followed by %(IPv6 interface name)	Specify an interface name with the percent (%) interposed when
	specifying a link local address.
network-filter: low end of range (<Value1>	In the between specification, lower limit of the mask range is greater
bits) is greater than high end (<Value2> bits)	than upper limit. Reduce lower limit value of the mask range to less
	than upper limit value.
	<Value1>: Lower limit of mask range
	<Value2>: Upper limit of mask range
network-filter: low end of range <Mask1>	In the between specification, lower limit of mask range is overlapped.
shorter than prefix mask <Mask2>	Correct the value so the mask range does not overlap with specified
	mask.
	<Mask1>: Lower limit of specified mask range
	<Mask2>: Specified mask
network-filter: mask not contiguous	Bit 1 of the specified mask does not continue. Use a mask where bit
	1 continues.
network-filter: network-filter name "<Name>"	The specified ID exceeds 15 characters. Specify ID by 15 or less
longer than 15 characters	characters.
	<Name>: Specified ID
network-filter: Non-masked bits not zero for	At mask, 1 is set to non-masked bit of the specified address. Set
<Address> mask <Mask>	non-masked bit 0.
	<Address>: Specified address
	<Mask>: Specified mask
network-filter: Non-masked bits not zero for	At masklen, 1 is set to non-masked bit of the specified address. Set
<Address> masklen <Masklen>	non-masked bit 0.
	<Address>: Specified address
	<Masklen>: Specified mask length
network-filter: out of range	The parameter-specified range is exceeded in the input command
	syntax. Numeric values of more than 4294967296 are contained.
	Reconfirm a parameter.
network-filter: syntax error	Syntax error
options: error resolving ’<Host Name>’:	The specified host name cannot be found. Specify the defined host
Unknown host	name.
	<Host Name>: Specified host name
options: gen-prefix-route option can be	A gen-prefix-route option cannot be specified when an interface in
specified only with the composition with the	which the network of local and remote addresses differs exists in a
same network of the both ends of an	point-to-point interface. Make identical the network of the local and
point-to-point interface.	remote addresses in a point-to-point interface when specifying a
	gen-prefix-route option.

5-38	GR2K-GA-0014
	Ver. 07-02