Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-5 Routing Protocol Error Messages (continued)

import: invalid number of route-filter lists value

Specified route filter count is over the limit. Specify the count up to 8.

at <Value> not in range 1 to 8

 

<Value>: Specified route filter count

 

 

import: invalid octet value at <Value> not in

More than 255 values are defined in dot notation. Specify value

range 0 to 255

within the range of 0 to 255.

 

 

 

<Value>: Specified value

 

 

import: invalid preference value at <Value>

Preference value is invalid. Specify a value within the range of 2 to

not in range 2 to 255

255.

 

 

 

<Value>: Specified preference value

 

 

import: invalid policy group number value at

Policy group number value is out of valid range. Specify value within

<Group Number> not in range 1 to 16

the range of 1 to 16.

 

 

 

<Group Number>: Specified policy group number

 

 

import: invalid range end: <Value>

In aspath_term{m,n}, m>n or n is more than 256. Set a start value

 

less than the end value or assign a value less than 255 to the end

 

value.

 

 

 

<Value>: Specified end value (n)

 

 

import: invalid range start: <Value>

In aspath_term {m, n}, {m}, {m,}, more than 256 is specified for m.

 

Use a value less than 255.

 

 

 

<Value>: Specified start value (m)

 

 

import: invalid route-filter number value at

ID number is out of valid range. Specify value within the range of 1 to

<Value> not in range 1 to 65535

65535.

 

 

 

<Value>: Specified ID number

 

 

import invalid vpn number value at <Value>

VPN number is out of valid range. Specify a value within the range of

not in range 1 to <Max_Value>

1 to <Max_Value>.

 

 

 

<Value>: Specified VPN number

 

<Max_Value>Maximum VPN number

 

 

import: IPv6 Interface not found at ’<Interface

The interface of the specified interface name cannot be found.

name>’

Specify it by using the defined interface name.

 

 

 

<Interface name>: Specified interface name

 

 

import: IPv6 prefix cannot be linklocal in

The link local address is specified in the network address. Do not use

configuration

the link local address.

 

 

import: IPv6 prefix cannot be multicast in

The multicast address is specified in the network address. Do not

configuration

use the multicast address.

 

 

import: linklocal address should be followed

An interface name is not specified in the specified link local address.

by %(IPv6 interface name)

Specify an interface name with the percent (%) interposed when

 

specifying a link local address.

 

 

import: low end of range (<Value1> bits) is

In the between specification, lower limit of the mask range is greater

greater than high end (<Value2> bits)

than upper limit.Reduce lower limit value of the mask range to less

 

than upper limit value.

 

 

 

<Value1>: Lower limit of mask range

 

<Value2>: Upper limit of mask range

 

 

import: low end of range <Mask1> shorter

In the between specification, lower limit of the mask range is

than prefix mask <Mask2>

overlapped with specified mask. Correct the value so the mask range

 

does not overlap with specified mask.

 

 

 

<Mask1>: Lower limit of specified risk range

 

<Mask2>: Specified mask

 

 

import: mask not contiguous

Bit 1 of the specified mask does not continue. Use a mask where bit

 

1 continues.

 

 

import: metric option of route-filter must not be

The metric option for the route filter is defined in the import filter or

define for {import filter bgp bgp4+}

the BGP/BGP4+ protocol. Do not specify the metric option.

 

 

import: Non-masked bits not zero for

At mask, 1 is set to non-masked bit of the specified address. Set

<Address> mask <Mask>

non-masked bit 0.

 

 

 

<Address>: Specified address

 

<Mask>: Specified mask

 

 

5-36

GR2K-GA-0014

 

Ver. 07-02

Page 426
Image 426
Hitachi GR2000 Series manual Mask1 Lower limit of specified risk range