Hitachi GR2000 Series manual Num

	Configuration Error Messages
Table 5-6 Multicast Router Control Information Error Messages (continued)
pim: invalid max-interfaces value at ’<Num>’	PIM-SM does not support max-interfaces values.
	<Num>: The maximum number of specified interfaces
pim: mask not contiguous	The specified mask for rendezvous point candidates of PIM-SM is
	not continuous at bit 1. Specify a mask that is continuous at bit 1.
pim: Non-masked bits not zero for <Group	In the group of rendezvous point candidates of PIM-SM, the
address> / <Masklen>	non-mask bit of the specified masklen address is set to "1." Set the
	non-mask bit to "0."
	<Group address>: specified multicast group address
	<Masklen>: Specified mask length
pim: Non-masked bits not zero for <Group	In specifying a mask for the group of rendezvous point candidates of
address> mask <Mask>	PIM-SM, the non-mask bit of the specified address is set to "1." Set
	the non-mask bit to “0.”
	<Group address>: specified multicast group address
	<Mask>: Specified mask
pim: Non-masked bits not zero for <Group	In specifying masklen for the group of rendezvous point candidates
address> masklen <Masklen>	of PIM-SM, the non-mask bit of the specified address is set to "1."
	Set the non-mask bit to “0.”
	<Group address>: specified multicast group address
	<Masklen>: Specified mask length
pim: octet or hex string too long to be an IP	The specified IP address format is abnormal. Specify the correct dot
address	format.
pim:ssm is not defined	Though the "ssm-join" command has been defined, the "ssm"
	command has not been defined.
pim: the parameter must be a group address	The group address specified for rendezvous point candidates of
(class D)	PIM-SM is illegal. For the group address, specify a Class-D IP
	address.
pim: the total number of enable interfaces is	The total number of interface addresses specified to be enable in the
more than the max-interfaces value (<Num>)	pim definition has exceeded the value specified by max-interfaces
	(<Num>). Specify the addresses so that the number of interface
	addresses specified to be enable is less than the value specified by
	max-interfaces (<Num>). The maximum value for the max-interfaces
	is 256. If addition of the interface definition for PIM is wanted, add the
	definition after having increased the value of the max-interfaces.
	If deletion the interface definition of PIM is wanted, delete the
	interface definition so that the number of interface addresses
	specified to be enable is less than the value of the max-interfaces
	(<Num>).
	<Num>: Specified number of the maximum interfaces.

GR2K-GA-0014	5-59
Ver. 07-02