Hitachi GR2000 Series manual Maximum specifiable count of 1 rule

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-18 Address Translaion Information Error Messages (continued)

nat:option requires an argument -- service	"service" is an essential option with the specified NAT type.
	Set the "service" option.
nat:Can not specify "auto" to a source IP	It is not possible to specify pre-translation IP addresses as "auto"
address.	with the specified NAT type.
	Set the correct pre-translation IP address and mask length.
nat:Can not specify "auto" to a translation IP	It is not possible to specify post-translation IP addresses as "auto"
address.	with the specified NAT type.
	Set the correct pre-translation IP address and mask length.
nat:source: IP address must be network	The pre-translation IP address is not a network address for the
address,because network mask length is not	specified mask length.
32.	Set the correct pre-translation IP address and mask length.
nat:translation: IP address must be network	The pre-translation IP address is not a network address for the
address,because network mask length is not	specified mask length.
32.	Set the correct post-translation IP address and mask length.
nat:NAT translation IP address range over.	The post-translation IP address count of the specified range exceeds
	the maximum specifiable count of 1 rule.
	Set the correct post-translation IP address range.
nat:NAT translation IP address range count	The post-translation IP address count of the specified range exceeds
over.	the maximum specifiable count of 1 rule.
	Set the correct post-translation IP address range.
nat:Unmach NAT IP address count.	The pre-translation IP address count of the specified range does not
	coincide with the post-translation IP address count of the specified
	range in static NAT.
	Set the pre-translation IP address count of the specified range the
	same as the post-translation IP address count of the specified range.
Can not set nat configuration because	It is not possible to set nat configuration information because
qos_ip_list or filter_list configuration is already	qos_ip_list or filter_list is set.
defined.	It is necessary to delete "qos_ip_list" or "filter_list" in order to set nat.
Can not set nat because there are 2000	It is not possible to set nat configuration information because the
entries in all or more, nat configuration and	total entry count of nat configuration information and flow
flow configuration.	configuration information that can be set per RP exceeds the RP
	settable entry count.
	Delete flow configuration information.
Can not set nat because nat reservation entry	It is not possible to set nat configuration information because
is used by flow configuration.	reserved entries of nat configuration information are being used by
	flow configuration information.
	Re-reflect configuration information by the "config copy" command in
	order to set nat configuration information.
Can not set nat configuration,qos_ip_list or	It is not possible to simultaneously set nat configuration information
filter_list configuration simultaneously.	and "qos_ip_list" or "filter_list" in configuration information files.
	Delete "qos_ip_list" or "filter_list" in order to set nat configuration
	information.
	Or, delete nat configuration information in order to set "qos_ip_list" or
	"filter_list."

5-98	GR2K-GA-0014
	Ver. 07-02