Hitachi GR2000 Series manual GR2K-GA-0014

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-5 Routing Protocol Error Messages (continued)

static: invalid octet value at <Value> not in	More than 255 values are defined in dot notation. Specify value
range 0 to 255	within the range of 0 to 255.
	<Value>: Specified value
static: invalid pollcount value at xxx not in	Polling count is out of valid range. Specify value within the range of 1
range 1 to 10	to 10.
	<Value>: Specified polling count
static: invalid pollinterval value at <Value> not	Polling timer value is out of valid range. Specify value within the
in range 5 to 180	range of 5 to 180.
	<Value>: Specified polling timer value
static: Invalid pollinterval	Polling timer value is invalid. Specify value in the multiples of 5.
static: invalid preference value at <Value> not	Preference value is invalid. Specify a value within the range of 2 to
in range 2 to 255.	255.
	<Value>: Specified preference value.
static: invalid vpn number value at <Value>	VPN number is out of valid range. Specify value within the range of 1
not in range 1 to <Max_Value>	to <Max_Value>.
	<Value>: Specified VPN number
	<Max_Value>Maximum VPN number
static: IPv6 prefix cannot be linklocal in	The link local address is specified in the network address. Do not use
configuration	the link local address.
static: IPv6 prefix cannot be multicast in	The multicast address is specified in the network address. Do not
configuration	use the multicast address.
static: IPv6 static interface statement should	The broadcast interface is specified in the specified interface in the
be used for non- broadcast I/F	static definition. To specify the interface, specify the point-to-point
	interface.
static: linklocal address should be followed by	An interface name is not specified in the specified link local address.
%(IPv6 interface name)	Specify an interface name with the percent (%) interposed when
	specifying a link local address.
static: mask not contiguous	Bit 1 of the specified mask does not continue. Use a mask where bit
	1 continues.
static: multipath option not valid for vpn route	The multipath option has been defined relative to the VPN route.
	Do not define the multipath option relative to the VPN route.
static: Non-masked bits not zero for	In the mask specification, 1 is set to the non-masked bit of the
<Address> mask <Mask>	specified address. Set non-masked bit 0.
	<Address>: Specified address
	<Mask>: Specified mask
Static: Non-masked bits not zero for	In the masklen specification, 1 is set to the non-masked bit of the
<Address> masklen <Masklen>	specified address. Set non-masked bit 0.
	<Address>: Specified address
	<Masklen>: Specified mask length
static: not IPv6 prefix	Addresses other than an IPv6 prefix are specified. Specify IPv6
	prefix.
static: out of range	The parameter-specified range is exceeded in the input command
	syntax. Numeric values of more than 4294967296 are contained.
	Reconfirm a parameter.
static: poll option not valid for vpn	Polling option is defines in a VPN remote route. Do not define a
remote-gateway	polling option in a VPN remote route.
static: remote-gateway <IPv6 Prefix> is not	Addresses other than a global address or site local address are
global/site-local IPv6 address	specified. Specify the global address or site local address for
	remote-gateway. <IPv6 Prefix>: Specified local address
static: syntax error	Syntax error
The total number of {targetsIPv6 static	Total number of specified targets is more than maximum acceptable
gateways} (<Value>) is more than the	value. Specify a number up to 256.
maximum permitted (256)
	<Value>: Total number of specified targets

5-50	GR2K-GA-0014
	Ver. 07-02