Hitachi GR2000 Series manual DVMRP, IGMP, Dvmrptunel

	Configuration Error Messages
Table 5-6 Multicast Router Control Information Error Messages (continued)
multicast: invalid inet mask bits value at	The specified mask length in multicast definition is invalid. Specify
<Masklen> not in range 4 to 32	within the range of 4 to 32.
	<Masklen>: Specified mask length.
multicast: mask length out of range from 4 to	The specified mask pattern in multicast definition is invalid.
32	Specify mask pattern with length of 4 to 32.
multicast: mask not contiguous	The specified mask in multicast definition is not contiguous with bit 1.
	Specify the mask that bit 1 is contiguous.
multicast: Non-masked bits not zero for	1 is set to non-masked bits of address for masklen specification in
<Group address> / <Masklen>	multicast definition. Specify 0 to non-masked bits.
	<Group address>: Specified multicast group address.
	<Masklen>: Specified mask length.
multicast: Non-masked bits not zero for	1 is set to non-masked bits of address for mask specification in
<Group address> mask <Mask>	multicast definition. Specify 0 to non-masked bits.
	<Group address>: Specified multicast group address.
	<Mask>: Specified mask.
multicast: Non-masked bits not zero for	1 is set to non-masked bits of address for masklen specification in
<Group address> masklen <Masklen>	multicast definition. Specify 0 to non-masked bits.
	<Group address>: Specified multicast group address.
	<Masklen>: Specified mask length.
multicast: octet or hex string too long to be an	The specified IP address format is invalid.
IP address	Specify in the correct dot format.
multicast:ssm-join is not supported in	The "ssm-join" command is defined when using DVMRP, IGMP and
DVMRP, IGMP, DVMRPTUNEL.	DVMRPTUNEL.
multicast:The combination total of GROUP	The sum total of groups and sources defined by "ssm-join" exceeds
and SOURCE exceeded the maximum	the allowable limit. Set the sum total of groups and sources to a
permitted	maximum of 256.
multicast:join and staticjoin are not supported	"join" and "staticjoin" are not supported with PIM-SM.
in PIN-SM
multicast: the parameter must be a group	The group address specified in multicast definition is invalid.
address (class D)	Specify the group address by IP address of class D.
multicast: this address is not supported	The specified group address in multicast definition is not supported.
<Group address>	Specify the group address by IP address of class D.
	<Group address>: Specified multicast group address.
multicast:this source address is not supported	The range for specifying local addresses specified by "ssm-join" is
<Source address>	invalid. Specify IP addresses of classes A - C.
	<Source address>: local address specified by the "ssm-join"
	command
PIM and DVMRP can not be set up	The PIM and the DVMRP cannot be set simultaneously. Define only
simultaneously.	either one of the PIM information (pim) or the DVMRP information
	(igmp, dvmrp, dvmrptunnel).
PIM-SM and multicast can not be set up	PIM-SM does not support multicast settings.
simultaneously.
pim: can not check configuration, please try	The configuration definition cannot be checked because actuation of
again	the multicast routing program has not been completed. Try it again
	after some time.
pim: can not set candidate-bsr on this router	Unless the device address is defined, there is no setting BSR
which is not configured to router	candidates. First set the device address.
local_address
pim: can not set candidate-rp on this router	Unless the device address is defined, there is no setting rendezvous
which is not configured to router	point candidates. First set the device address.
local_address

GR2K-GA-0014	5-57
Ver. 07-02