Hitachi GR2000 Series manual This parameter specifies the Icmp type, List of Igmp Type Number

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

-Checkspairsynchronizedthe source and the destination IP addresses, and upper-level source and destination protocol port numbers by simultaneously switching the values (synchronized check). To

run the source and destination IP address

check, specify: -ip_pair_off. For the synchronized port

number check, specify: -port_pair_ off (see note 1).

Default:	_	_off
Description:type	This parameter specifies the ICMP type.
Default:	None (ICMP type is not a flow detection condition).
ccodeRange of value: 0-255
Description:	This parameter specifies the ICMP code.
Default:	None (ICMP code is not a flow detection condition).
-igmpRange of<Novalue:.>	0-255
Description:	This parameter specifies the IGMP type.
Default:	None (IGMP type is not a flow detection condition).
Range of value: 0-255
Table 1-85 List of IGMP Type Number
IGMP Type No. (HEX)	Input Value (Decimal)		Name
0x11	17		Membership Query
0x12	18		Version 1 Membership Report
0x13	19		DVMRP protocol
0x16	22		Version 2 Membership Report
0x17	23		Version 2 Leave Group
0x22	34		Version 3 Membership Report

-branchDescription:index<No.>This parameter specifies a connection branch Index number (DLCI group information or Index specified using VC-Group information). This parameter selects and sends the specified DLCI/VC information in a group when it relays a packet that coincides with QoS IP frame conditions. For the QoS IP frame conditions under which the connection branch Index number is set, specify parameter -out (Outbound) and set it as QoS IP frame conditions on the output side when setting IP QoS information. See 1.2.8 in this guide.

Default:None

Range of value: 0-7

1-174	GR2K-GA-0014
	Ver. 07-02