Hitachi GR2000 Series manual Configuration file do not modified to standby

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-25 Other Error Messages (continued)

Configuration file copy failed.	Configuration file copy failed. Execute the command again after
	removing the factors causing the following errors.
	1. Confirm the MC card’s mounting status and the remaining
	capacity in the standby system using the show mc command (*1).
	2. Confirm the RM’s CPU use rate using the show “rm cpu”
	command (*2).
Configuration file copy failed because cached	Because configuration file cannot be copied to cached configuration
configuration file create failed.	file, configuration file copy is failed. Execute the command again
	after removing the factors causing the following errors.
	1. Confirm the MC card’s mounting status and the remaining
	capacity in the standby system using the show mc command (*1).
	2. Confirm the RM’s CPU use rate using the show “rm cpu”
	command (*2).
Configuration file do not copy to standby RM	Standby configuration file copy failed. Confirm setting information
because standby RM is not ready.	and the rest memory size of standby MC card using the show mc
	command, and then execute again after eliminating causes of error.
Configuration file do not modified to standby	Because standby configuration information is opened, configuration
RM because configuration file is opened in	file copy failed. Close standby configuration, and then execute the
standby RM.	command again.
Configuration file do not modified to standby	Because standby configuration information cannot be modified,
RM because standby RM is not ready.	configuration file copy failed. Eliminate the error and execute the
	command again.
	1. Confirm the standby MC card’s mounting status and the
	remaining capacity in the standby system using the “show me”
	command (*1).
	2. Confirm the RM’s CPU use rate using the show “rm cpu”
	command (*2).
	3. Confirm that the standby system RM board has been inserted
	into this device correctly.
Configuration file is already closed.	Current or spare configuration file already closed. Before entering
	configuration information, open current or spare configuration file.
Configuration file is already opened,	Current or spare configuration file already opened. Command could
configuration file did not copy.	not be executed successfully. Before entering configuration
	information, close current or spare configuration file.
Configuration file is already opened.	Current or spare configuration file already opened. Close current or
	spare configuration file.
Configuration file not found.	Target current or spare configuration file not found. Specify correct
	current or spare configuration file and execute again.
Configuration file save error.	Current or spare configuration file cannot be saved. Using the show
	mc command, check the installation status of the MC card, remaining
	MC card memory and other statuses.
Current configuration file was successfully	Current configuration information file was copied, but because
changed. Configuration file do not copy to	standby RM is not started up, standby configuration information is
standby RM because standby RM is not	not copied. When updating standby configuration file, start up
ready.	standby and reflect by using config copy command.
Current configuration file was successfully	Current configuration information file was copied, but because
changed. Configuration file do not modified to	standby configuration information cannot be copied to cached
standby RM because cached configuration file	configuration file, standby configuration information is not reflect.
create failed.	When updating standby configuration file, confirm the rest memory
	size of MC card by using show mc command, and then reflect by
	using config command after eliminating causes of error.
Current configuration file was successfully	Current configuration information file was copied, but because
changed. Configuration file do not modified to	current configuration file cannot be copied to standby configuration
standby RM because configuration file copy	file, standby configuration information is not reflected. When
failed.	updating standby configuration file, confirm setting status and the
	rest memory size of MC card by using show mc command, and then
	reflect by using config command after eliminating causes of error.
5-104	GR2K-GA-0014
	Ver. 07-02