Hitachi GR2000 Series manual Definition does not exceed the value Num2 specified for

	Configuration Error Messages
Table 5-6 Multicast Router Control Information Error Messages (continued)
pim: the total number of enable interfaces is	The total number of interface addresses set to “enable” in the PIM
more than the maximum number of interfaces	definition does not exceed the value (<Num2>) specified for
that this router runs (<Num1>) though it is less	max-interfaces. But the number exceeds the maximum number of
than the max-interfaces value (<Num2>)	interfaces running on the system (<Num1>). Set the number of
	enable-specified interface addresses to <Num1> or less.
	To add an interface definition, take the following steps:
	(1) Execute the config apply command.
	(2) Execute the restart ipv4-multicast command.
	(3) Add an interface address of PIM.
	<Num1>: The maximum number of interfaces running on the system.
	<Num2>: The number of specified interfaces.
pim: the total number of groups on	The total number of group addresses of rendezvous point candidates
candidate-rp is more than the maximum	exceeds the maximum capacity. Specify 128 addresses or less.
permitted (128)
pim: the total number of interfaces is more	The total number of interface addresses specified in the PIM
than the maximum permitted (<Num>)	definition exceeds the maximum capacity. Set the number of PIM
	addresses to <Num> or less.
	<Num>: The maximum number of specified interfaces
pim:the number of PIM-SSM groups is set up	The number of PIM-SSM group addresses that have been set
exceeding the maximum	exceeds the maximum limit. The maximum number is 1.
pim: this address is not supported <Group	The group address specified for PIM-SAM rendezvous point
address>	candidates is not supported. For the group address, specify a
	Class-D IP address.
	<Group address>: Specified multicast group address
<Command>: syntax error	Syntax error
	<Command>: Command name

GR2K-GA-0014	5-61
Ver. 07-02