Hitachi GR2000 Series manual Tunnel Interface Information, Information Group Name

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 4-12 List of Initial Values That Can Be Set Using ISDN Information and Initial Values During Initial Installation (continued)

Information Group Name

ISDN information (continued)

Information Name	Initial Value
Report of local IPX node number	The local IPX node number
	is not reported.
Transmission interval of Echo-RQ frame	3 seconds
Type of certified protocol	No certified protocol is used.
Overload connection procedure	Multi-link PPP connection
Monitoring interval of line usage rate during overloading	The overloading based on
based on monitoring of line usage rate	the monitoring of a line
	usage rate is not performed.
Direction for monitoring of line usage rate	Only the line usage rate
	during transmission is
	monitored.
Operation of resource BOD	Resource BOD is
	performed.
Number of ISDN backup connection retries when a	3 times
failure is detected during connection of ISDN at the
backup destination using resource BOD
Route change-back procedure of resource BOD	The route is changed back
	automatically.
Request of telephone number report to the remote	No telephone number is
router when a link is added in BAP using an outgoing	requested.
call
Initial value of remote MTU length when using multi-link	4500 bytes
PPP procedure
Request retry interval when the request of link addition	60 seconds
and deletion is rejected in BAP
Backup change-back operation	Automatic change-back
Surveillance time for manual cut-back.	80 seconds
ISDN logical port backup switchover and switchback	Executes call connection
action	prompted by information
	generation at the time of
	switchover and executes
	call disconnection prompted
	by the detection of
	no-communication status in
	information monitoring at
	the time of switchback.

4.7.13Tunnel Interface Information

Input Format

Parameters[set]-tunnel{default-tunnelmtuoptimize<MTU>][-offtunnel-tunnelttlhoplimitoptimize<TTL}]HopLimit>]

The initial value items that can be set using tunnel Information and the initial values during initial installation are shown in Figure 1-7.

4-50	GR2K-GA-0014
	Ver. 07-02