Hitachi GR2000 Series manual Port number and the destination upper protocol port number

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

-<SubnipDescription:destination<IPMaskBitLength>Address>[Specifies/<Subnet-the<IPdestinationAddres>MaskBitIPmaskLength>]address<Subnet. WhenMask>bothdestinationmasklen

and source addresses are set under one condition, set so that the specified addresses do not overlap. If they overlap, set an IP address pair switch ip-pair_of. (Note 1)

When specifying only one IP address: -ip_destination <IP

When specifying addresses within a range:

Specify the lower limit and upper limit of IP addresses:

Specify the subnet<IPmask:Address>-<IPAddress>

Specify the subnetmaskmask<Subnetlength:Mask>

or-ip_destination l <SubnetMaskBitLength>

You cannot directly/<SubnMaskBitmodify the subnetLength>mask or the subnet mask length for only one IP address. You must first delete the setting by entering delete filter-list <Filter List No.>

and then specify the IP address.

Default: Undefined.

Range of value: IP address: 0.0.0.0–255.255.255.255

Subnet mask: 255.0.0.0–255.255.255.255

Subnet mask bit length: 8–32

{-portDescription:pair-port_Specifiespairoff}the method for checking the source upper protocol

	port number and the destination upper protocol port number.
	The -port_pairoption checks for not switching and for
	switching source upper protocol port number with destination
	upper protocol port number (see Note later in this subsection).
	The -port_pair_offoption only checks for not switching
	source upper protocol port number with destination upper
	protocol port number. The -port_pairoption requires setting
	of the synchronized pair switch for the IP address upper
	protocol port number to off (-pair_synchronized_off).
Default:	On
Description:	Specifies the source upper protocol port number. When both
	source and destination upper protocol port numbers are set
	under one condition, set so that the specified upper protocol
-portsource<PortNoport.>[-numbers<PortNodo.>]not overlap. If they overlap, set an upper
	protocol port number’s pair switch as -port_pair_off. (Note 1)
	When specifying only one port number:
1-114	-port_source<PortNo.>	Ver. 07-02
		GR2K-GA-0014