Hitachi GR2000 Series manual For the flow control, refer to the GR2000 Applications Guide, 201

Filtering/QoS Information

Related Commands

Relatedqos-ipInformationdiscardmodequeueinterface-list-list-group

For the flow control, refer to the GR2000 Applications Guide.

Precautions

1. Multiple IP frame condition groups cannot be set as inbound/outbound in a

single .

2.When exp specified as a flow detection condition parameter by qos-ip-list, only "in" specification is valid on the entry. "out" specification is invalid in this case.

The entry valid only on the core router in an MPLS network. It is invalid on the entrance and exit edge routers in an MPLS network.

3.Only the interface specification in RP after RP-C or RP-D is valid for the IP QoS information when exp is specified as a flow detection condition parameter by

-listor when replace-expis specified as a flow control parameter. The interface specification in RP other than described above is invalid.

4.If this command is inputted in the cases where changes are made on the IP routing protocol information, the IP multicast protocol information, and the MPLS information, and the apply command is not being executed, the apply subcommand is executed before the command is executed, and the changed IP routing protocol information, IP multicast routing protocol information, and MPLS information are reflected to the operation.

1.2.8qos-ip(Information on IP QoS of the Old BSD UNIX-based Command System)

Establishes the IP QoS settings. The Qos IP frame condition group is determined against the interface defined in the IP or IP-address settings. When IP QoS settings are established, QoS is determined against the receipt packet or transmission packet in an applicable interface. A maximum of 512 entries can be generated per device (maximum interface 256, inbound/outbound for one interface).

Input Format

Settings

ChangeTimesltsettingsName><PeerName><DLCI<VCName>}{<Group-inName>-out}

Delete settings
GR2K-GA-0014	-<[set]qosiplistgroup<qos-ip{Line-ip-list-<group		<	1-201
Ver. 07-02	GroupName>TmslotName>	VPVC<PerName>DLCI<VC		}{-in-out}
	delete<Per-ip{<VC	}{-in-out}		<TimeslotName>