Hitachi GR2000 Series manual 1 qos, Non-IP protocol QoS control, Setting information, No disable

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

	1.2.7 qos-tos-map
	Sets from qos-tos-map.
Flow Control (input)		Flow Control (output) Queue Control			Transmission Control
Flow Detection	Priority Determination	Route Search	Flow Detection	Priority Determination
	TOS Rewrite			TOS Rewrite
	Contracted Bandwidth			Contracted Bandwidth	Interface
	Monitoring			Monitoring	(LINE,DLCI, etc.)

: Control range￿of this command

Figure 1-8 Range of TOS-QoS Conversion Table Information Control

6. Non-IP protocol QoS control

Non-IP protocol (IPX, Bridge, HDLC, etc.) QoS control is set using three commands: IPX QoS (qos-ipx), bridge QoS (qos-bridge), and HDLC QoS (qos-hdlc). These define QoS control for IPX, Bridge, and HDLC protocols, respectively.

1.2.9 qos-ipx

1.2.10 qos-bridge

￿1.2.11 qos-hdlc

1.2.1 qos

This command sets the use and disuse of flow control. The setting of use and disuse is enabled when the flow control is set using the old, BSD UNIX-based command system (qos-ip-hst, quos-ip-hst-group, or qos-ip). The setting of use and disuse in this command is disabled when the flow control is set using a flow command. Set the use and disuse using a flow command when setting the flow control using a flow command.

Input Format

Setting information

Modifying[set]qos{information-no-yes}[-cops][-wan_length_mode{shortlong}]

Deleting information

Displayingdeleteinformationqos

Parametersshow

{Description:-no-yes}enable/disable flow control

-no: disable

1-134	GR2K-GA-0014
	Ver. 07-02