Configuration Error Messages

 

 

Table 5-5 Routing Protocol Error Messages (continued)

 

 

export: invalid {RIPRIPng} metric value at

In export definition, the RIP/RIPng metric is invalid. Specify a value

<Metric> not in range 1 to 16

within the range of 1 to 16.

 

 

 

<Metric>: Specified metric value

export: invalid route-filter number value at

The specified ID number is invalid. Specify within the range of 1 to

<Value> not in range 1 to 65535

65535.

 

 

 

<Value>: Specified ID number

export: invalid vpn number value at <Value>

The specified vpn number is invalid. Specify within the range of 1 to

not in range 1 to <Max_Value>

<Max_Value>.

 

 

 

<Value>: Specified VPN number

 

<Max_Value>Maximum VPN number

export: IPv6 Interface not found at ’<Interface

The interface of the specified interface name cannot be found.

name>’

Specify it by using the defined interface name.

 

 

 

<Interface name>: Specified interface name

export: IPv6 prefix cannot be linklocal in

The link local address is specified in the network address. Do not use

configuration

the link local address.

export: IPv6 prefix cannot be multicast in

The multicast address is specified in the network address. Do not

configuration

use the multicast address.

export: linklocal address should be followed

An interface name is not specified in the specified link local address.

by % (IPv6 interface name)

Specify an interface name with the percent (%) interposed when

 

specifying a link local address.

export: low end of range <Mask1> shorter

In the between specification, mask range lower limit value is

than prefix mask <Mask2>

overlapped with specified mask. Specify the value so the mask range

 

does not overlap with specified mask.

 

 

 

<Mask1>: Specified mask range of lower limit

 

<Mask2>: Specified mask

export: low end of range (<Value1> bits) is

In the between specification, mask range lower limit value is greater

greater than high end (<Value2> bits) is

than upper limit. Reduce lower limit value to less than upper limit

greater

value.

 

 

 

<Value1>: Lower limit of Mask range

 

<Value2>: Upper limit of Mask range

export: mask not contiguous

Bit 1 of specified mask does not continue. Use a mask where bit 1

 

continues.

export: metric option of route-filter must not be

The metric option for the route filter is defined against the BGP/

define for {bgpbgp4+}

BGP4+ protocol. Do not specify the metric option.

export: Non-masked bits not zero for

At mask, 1 is set to non-masked bit of specified address. Set

<Address> mask <Mask>

non-masked bit 0.

 

 

 

<Address>: Specified address

 

<Mask>: Specified mask

export: Non-masked bits not zero for

At masklen, 1 is set to non-masked bit of specified address. Set

<Address> masklen <Masklen>

non-masked bit 0.

export: not IPv6 prefix

Addresses other than an IPv6 prefix are specified. Specify the IPv6

 

prefix.

export: out of range

The parameter-specified range is exceeded in the input command

 

syntax. Numeric values of more than 4294967296 are contained.

 

Reconfirm a parameter.

export: preference option of route-filter must

The preference option for the route filter is defined in the export filter.

not be define for export filter

Do not specify the preference option.

export: route-filter name "< Name>" cannot be

The specified route filter contains invalid protocol information or

specified

network information. Specify the valid route filter name.

 

 

 

<Name>: Route filter name

export: route-filter name "<Name>" longer

The specified ID exceeds 15 characters. Specify ID by 15 or less

than 15 characters

characters.

 

 

 

<Name>: Specified ID

 

 

GR2K-GA-0014

5-33

Ver. 07-02

 

Page 423
Image 423
Hitachi GR2000 Series manual Does not overlap with specified mask