Hitachi GR2000 Series manual List of Interfaces that Support Flow Control

Range of value:

<IP Address>: Set the IPv6 address described below. IPv6 address :(nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn:nnnn): 0:0:0:0:0:0:0-ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff

SpecifiesAddress>:the next hop IPv6 address.

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

-drop: The agreed packet is discarded.

Default: -forward

Range of value: None

[-policyThis parameter<InterfaceenablesName>the<IPfunctionAddress>]of policy routing. Packets are transmitted to the output destination specified using this option when relaying the packets that coincide with filter conditions. For the list information that sets policy routing, specify in (Inbound) and then specify it as the flow control on the receive side.

<Interface Name>:

Specifies the interface name at the output destination (the interface name set using ip information) (refer toTable 1-34).

Table 1-34 List of Interfaces that Support Flow Control

Interface Name	Availability of Support
<Line Name>	√
RmEthernet	---
<DLCI Name>	√
<VC Name>	√
<Group Name>	√
<Timeslot Name>	√
<Peer Name>	√
<Tunnel Name>	---
<VLAN Name>	---(1*)
<Session Name>	--- (1*)

√: Setting possible.

-:Setting impossible

*1: VLAN line and PPOoE session are not supported.

<IP

Default: -forward

[-indexDesignate<No.>]the connection branching index numbers (indexes designated by the DLCI group information or the Vc-Group information). When relaying a packet that agrees with the flow detecting condition, DLCI/VC designated in the group is selected and transmitted. Designate "out" (Outbound) for the list information that has set the connection branching index number, as the flow control of the transmission side. It cannot be set in the tunnel interface.

Default: -forward

Range of value: 0 to 7.

1-50	GR2K-GA-0014
	Ver. 07-02