Hitachi GR2000 Series manual Definition is wanted, add it using the following procedure

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-6 Multicast Router Control Information Error Messages (continued)

pim: the total number of enable interfaces is	The total number of interface addresses specified to be enable in the
more than the max-interfaces value (<Num1>)	pim definition is less than the maximum number of the interfaces in
though it is less than the maximum number of	which this device is operating (<Num2>), but the value specified by
interfaces that this router runs (<Num2>)	the max-interfaces (<Num1>) has been exceeded. Specify the
	addresses so that the number of interface addresses specified to be
	enable is less than the number (<Num1>). If addition of the interface
	definition is wanted, add it using the following procedure:
	(1)	Increase the value of the max-interface. However, the maximum
	value for the max-interface is 256.
	(2)	Execute the config apply command.
	(3)	Execute the Operations Guide -New Syntax Operation
	Command, Vol. 1- restart ipv4-multicast command.
	(4)	Add the interface address of PIM.
	If deletion of the interface definition is wanted, add it using the
	following procedure:
	(1)	Delete the interface definition so that the number of interface
	addresses specified to be enable is less than the value of the max
	interfaces (<Num1>).
	(2)	Decrease the value for the max-interfaces. However, the
	minimum value for the max-interfaces is 32.
	(3)	Execute the config apply command.
	(4)	Execute the restart ipv4-multicast command.
	<Num1>: Maximum number of interfaces in which this device is
	operating.
	<Num2>: Maximum specified number of interfaces
pim: the total number of enable interfaces is	The total number of interface addresses specified to be enable in the
more than the max-interfaces value at the	pim definition has exceeded the value of the max-interfaces when
config apply command execution (<Num>)	the config apply command has been executed in the previous run
	(<Num>). If change in the value of the max-interfaces is wanted
	execute the config apply command and the restart ipv4-multicast
	command in that order.
	(1)	Execute the config apply command.
	(2)	Execute the restart ipv4-multicast command.
	(3)	Add the interface address.
	<Num>: The maximum number of specified interface at executing
	config apply command last time.
pim: the total number of enable interfaces is	The total number of interface addresses specified in the pim
more than the maximum permitted (32)	definition has exceeded the maximum allowance.
	Specify the addresses so that the number of enable interface
	addresses of PIM is 32 or less.
pim: the total number of enable interfaces is	In PIM definitions, the total number of interface addresses set to
more than the maximum number of interfaces	“enable” exceeds the maximum number of interfaces run on the
that this router runs (<Num>)	system (<Num>). Set the number of enable-specified interface
	addresses to <Num> or less. To add an interface definition, take the
	following steps:
	(1) Increase the value of max-interfaces. The value can be increased
	up to 256.
	(2)	Execute the config apply command.
	(3)	Execute the restart ipv4-multicast command.
	(4)	Add interface addresses for PIM.
	<Num>: The maximum number of interfaces run on the system.

5-60	GR2K-GA-0014
	Ver. 07-02