Hitachi GR2000 Series manual Operation Parameter, Default -forward None, Availability of Support

Range of value:

-forward:The agreed package is relayed. -drop :The agreed packet is discarded.

None (No default is possible when designating the operation.)

Default:

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Operation Parameter

[-action]If the operation parameter is either set or changed, please be sure to set this parameter at the head of the whole operation parameter.

Range of value: None

[{-forwardOperationwhich-drop}]agrees with the flow detecting condition is designated.

Default: -forward

None

[-policyThe policy<Interfacerouting Name>function<IPisAddress>]made effective. When relaying a packet that agrees
￿	with the filter condition, the packet is transmitted to the output destination
	designated by this option. Designate "in" (Inbound) for the list information that
	has set the policy routing, as the flow control of the reception side.
	<Interface Name>: Designate the interface name of the output destination (the
	interface name set in the information). (Refer toTable 1-27.))
Table 1-27 List of Interfaces Supporting Flow Control
Interface Name		Availability of Support
<Line Name>		√
RmEthernet		---
<DLCI Name>		√
<VC Name>		√
<Group Name>		√
<Timeslot Name>		√
<Peer Name>		√
<Tunnel Name>		---
<VLAN Name>		---(1*)
<Session Name>		--- (1*)

√: Setting possible.

-:Setting impossible

*1: VLAN line and PPOoE session are not supported.

<IPDefault:Address>:DesignateforwardthenexthopIPv4address.

Range of value: <IP Address>: Set the IPv4 addresses shown below:

Class 1.0.0.1-126.255.255.254

Class B 128.1.0.1-191.254.255.254

Class C 192.0.1.1-233.255.254.254

1-34	GR2K-GA-0014
	Ver. 07-02