Hitachi GR2000 Series manual Route-filter syntax error Syntax error

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 5-5 Routing Protocol Error Messages (continued)

route-filter: invalid vpn number value at	Vpn number specification range is invalid. Specify value within the
<Value> not in range 1 to <Max_Value>	range of 1 to <Max_Value>.
	<Value>: Specified vpn number
	<Max_Value>Maximum VPN number
route-filter: ipv4 protocol and ipv6 protocol	ipv4 routing protocol information exists together with ipv6 routing
must not be intermingled: <Name>	protocol information. Specify the two information items so that they
	do not coexist in one route filter name.
	<Name>: Route filter name
route-filter: IPv6 prefix cannot be linklocal in	The link local address is specified in the network address. Do not use
configuration	the link local address.
route-filter: IPv6 prefix cannot be multicast in	The multicast address is specified in the network address. Do not
configuration	use the multicast address.
route-filter: linklocal address should be	An interface name is not specified in the specified link local address.
followed by %(IPv6 interface name)	Specify an interface name with the percent (%) interposed when
	specifying a link local address.
route-filter: low end of range <Mask1> shorter	In the between specification, lower limit of the mask range is
than prefix mask <Mask2>	overlapped with specified mask. Correct the value so the mask range
	does not overlap with specified mask.
	<Mask1>: Lower limit of specified mask range
	<Mask2>: Specified mask
route-filter: low end of range (<Value1> bits) is	In the between specification, lower limit of the mask range is greater
greater than high end (<Value2> bits)	than upper limit. Reduce lower limit value of the mask range to less
	than upper limit value.
	<Value1>: Lower limit of mask range
	<Value2>: Upper limit of mask range
route-filter: mask not contiguous	Bit 1 of the specified mask does not continue. Use a mask where bit
	1 continues.
route-filter: network-filter name "<Name>"	The specified ID exceeds 15 characters. Specify ID by 15 or less
longer than 15 characters	characters.
	<Name>: Specified ID
route-filter: network-filter not found at <Value>	The specified ID number is not defined. Specify a defined ID number
	<Value>: specified ID number
route-filter: Non-masked bits not zero for	At mask, 1 is set to non-masked bit of the specified address. Set
<Address> mask <Mask>	non-masked bit 0.
	<Address>: Specified address
	<Mask>: Specified mask
route-filter: Non-masked bits not zero for	At masklen, 1 is set to non-masked bit of the specified address.
<Address> masklen <Masklen>	Set non-masked bit 0.
	<Address>: Specified address
	<Masklen>: Specified mask length
route-filter: not IPv6 prefix	Addresses other than an IPv6 prefix are specified. Specify IPv6
	prefix.
route-filter: out of range	The parameter-specified range is exceeded in the input command
	syntax. Numeric values of more than 4294967296 are contained.
	Reconfirm a parameter.
route-filter: route-filter name "<Name>" longer	The specified ID exceeds 15 characters. Specify ID by 15 or less
than 15 characters	characters.
	<Name>: specified ID
route-filter: route-filter sequence out of order	The specified order of a sequence number is incorrect. Specify a in
	ascending sequence.
route-filter: Set-attribute not found at <Value>	The specified ID number is not defined. Specify a defined ID number
	<Value>: Specified ID number
route-filter: syntax error	Syntax error

5-48	GR2K-GA-0014
	Ver. 07-02