Hitachi GR2000 Series manual Logger-email-fromLog E-Mail Transmission Source Information

Operation Management Information

When using e-mail messages and log e-mail simultaneously, do not set more than 1 entry for log e-mail destination address and 1 entry for SMTP server. If defined with more than 1 entry, e-mail transmissions may be delayed several minutes beyond the set time due to entry count and the load conditions of the SMTP server used for log e-mail and e-mail messages.

Characters usable in e-mail addresses are limited to lower- and upper-case alphabet, numerals, hyphen (-), dot (.) and "at" sign (@). Note that underscoring cannot be used. In addition, the "@" sign cannot be used at the

￿beginning or end of the address and no more than 1 can be used per address.

The e-mail address length is limited to a maximum of 255 characters. All characters beyond 255 are ignored if 256 or more characters are set.

4.2.3logger-email-from(Log E-Mail Transmission Source Information)

Function

Sets transmission source for output log information by e-mail. One entries can be set.

Input Format

To set information:

To delete[set]logggerinformation:email-from<E-MailAddress>

To showloggerAddress>information:--mail-from

Parametershow

<E-MailDescription:This parameter specifies the mail address of E-Mail transmission source.

Example

1.Setting of E-Mail transmission source information

The transmission source used during log E-Mail transmission is set to nobody@router-1.mydomain.com.:

Ver. 07-02	};logger(config)#email{sh-lggerfromwloggernobody@routeremail-fromnobod@router-1.mydomain.com;-1.mydomain.com	4-11
GR2K-GA-0014