Hitachi GR2000 Series manual Other Error Messages

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

5.25Other Error Messages

The following sub-commands (mainly, the open, close, save and copy sub-commands) are used for other purposes than for editing configuration definitions.

Table 5-25 Other Error Messages

Message	Contents
Bad address.	Access to MC card failed. Confirm setting status of MC card by using
	show mc command. When MC card is set correctly, wait for access,
	then execute again.
Cached configuration file is not created,	Because the contents of current configuration information file is not
current configuration file not be saved.	copied to temporarily saving configuration information file, current
	configuration information file is not saved.
	Eliminate the error and execute the command again.
	1. Confirm the MC card’s mounting status and the remaining
	capacity by using the show mc command (*1).
	2. Confirm the RM’s CPU use rate using the show “rm cpu”
	command (*2).
Can not execute config command in standby	Config command unavailable in standby RM.
RM.	Enter a config command in operation system.
CAUTION: Configuration file copy failed	Because configuration file cannot be copied to cached configuration
because cached configuration file create	file, configuration file copy failed. Confirm setting status and the rest
failed.	of memory size of MC card, and the execute again after eliminating
	causes of error.
CAUTION: Configuration file do not copy to	Standby configuration file copy failed. Confirm setting status and the
standby RM because standby RM is not	rest memory size of standby MC card by using show mc command,
ready.	and then execute the command again after eliminating causes of
	command.
CAUTION: Configuration file do not modified	Because standby configuration information is opened, configuration
to standby RM because configuration file is	file copy failed. Close standby configuration, and then execute the
opened in standby.	show mc command again.
CAUTION: Configuration file do not modified	Because standby configuration information cannot be modified,
to standby RM because standby RM is not	configuration file copy failed. Confirm status and operation of the
ready.	standby, and then execute the command again.
CAUTION: Current configuration file was	Current configuration file was copied, but because standby
successfully changed. Configuration file do	configuration information cannot be modified, standby configuration
not modified to standby RM because standby	information is not reflected. When updating standby configuration
RM is not ready.	file, confirm status and operation of standby, and then reflect by
	using config copy command.
	1. Confirm the MC card’s mounting status and the remaining
	capacity in the standby system using the show mc command (*1).
	2. Confirm the RM’s CPU use rate using the show “rm cpu”
	command (*2).
	3. Confirm that the standby system RM board has been inserted
	into this device correctly.
CAUTION: Current configuration file was	Current configuration file was copied, but because standby
successfu11y changed. Configuration file do	configuration information cannot be copied to cached configuration
not modified to stand by RM because cached	file, standby configuration information is not reflected.
configuration file create failed.	When updating standby configuration file, Confirm setting status and
	the rest memory size of standby MC card by using show mc
	command, and then reflect by using config copy command after
	eliminating causes of error.
CAUTION: Current configuration file was	Current configuration file was copied, but because standby RM is not
successfully changed. Configuration file did	ready, standby configuration file copy failed.
not copy to standby RM because standby RM	When updating standby configuration file, reflect after starting up
is not ready.	standby by using config copy.
5-102	GR2K-GA-0014
	Ver. 07-02