Hitachi GR2000 Series manual Or ip-address information. The ip information or

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 1-47 Operating Parameters that Can Be Set for Each Operation

Operation Parameter					Flow Control
	1	2(*1)	3(*2)	4	5(*1)	6(*2)	7	8(*1)	9(*2)	10	11
Priority designation by input IP packet							√	√	√
DSCP
-dscp_map
Contract band monitoring		x (*3)			x (*3)			x (*3)
-penalty_drop
Decision of priority by using DSCP of			√
input IP packet.			(∗4)
-penalty_discard <No.>
Abortion at contract band breach.						√				√
-penalty_dscp <DSCP_Value>						(∗4)				(∗4)
Output VC and DLCI designation	x	x	x	x	x	x	x	x		x
-index <Value>

√ : Indispensable x: Can be set, and default. No mark: Setting is impossible.

*1: This is the operating parameter of contract band monitoring. These conditions cannot be set when "-min_rate<kbps>[-min_rate_burst<Byte>]" is specified. To guarantee the minimum band, this parameter can only change the queuing priority of a packet that violates the contract band.

*2: This is the operating parameter of contract band monitoring. These conditions cannot be set when only "-max_rate<kbps> [-max_rate_burst<Byte>]" is specified. To limit the maximum band, this parameter can only discard a packet that violates the contract band.

*3: This is the operating parameter of contract band monitoring. Omit these conditions when "-max_rate<kbps>[-max_rate_burst<Byte>]" is specified.

*4: This is the operating parameter of contract band monitoring. The operation of a packet that violates the contract band of "-min_rate<kbps>" is specified when "-max_rate<kbps>[-max_rate_burst<Byte>] -min_rate<kbps>[min_rate_burst<Byte>]" is specified.

*5: No setting is possible on the VLAN line.

*6: Only VLAN lines can be set. In addition, output priority determination and DSCP rewrite cannot be set simultaneously.

<InterfaceDescription:name>	Specifies the subject interface name set in the ip information
	or ip-address information. (The ip information or the
	ip-address information should be set before inputting this
	command.) RM Ethernet and Tunnel interface are not
	supported. For details, refer to Table 1-5.
Default:	No default is possible.
{inDescription:out}	Specifies the Inbound/Outbound. Either one or both of the
	Inbound/Outbound can be set against one interface.
	in: Inbound (specification of the frame input side)
	out: Outbound (specification of the frame output side)
Default:	No default is possible.
Description:	Nullifies the flow control by input/output interface.
[-disable]Default:	Flow control is executed.
list<ListDescription:No.>	Specifies the list number.
1-88	GR2K-GA-0014
	Ver. 07-02