Hitachi GR2000 Series manual Default, Isdn Information Japan Only

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Table 4-11 List of Initial Values That Can Be Set Using ARM Information and Initial Values During Initial Installation (continued)

Information	Information Name	Initial Value
Group Name
VC information	Active/non-active state switching of VC	vc_enable (VC
		active state)
	Switching of mode in which Inverse ARP of an ATM line is used	inverse_arp
	or not used	(Inverse ARP is
		used.)
	MTU of ATM line	4470 bytes
	Setting of cell loss priority display bit	0 (CLP=0)
	Polling interval in VC state monitoring function using F5-OAM	no (The VC state
	loop-back cell (seconds)	monitoring
		function does not
		operate.)
	Number of response reception confirmation times during VC	3 times
	failure recovery in VC state monitoring function using F5-OAM
	loop-back cell (times)
	Number of non-response confirmation times during VC failure	5 times
	generation in VC state monitoring function using F5-OAM
	loop-back cell (times)
	Request transmission interval during VC failure generation/	1 second
	recovery in VC state monitoring function using F5-OAM
	loop-back cell (seconds)

4.7.12ISDN Information (Japan Only)

Note: ISDN settings are only valid in Japan.

*Software for using the model GR2000-B overseas currently allows the setting of ISDN functions. However, since hardware specifications do not support ISDN, a log message indicating an error is displayed if ISDN configuration definitions are set. In order to avoid this malfunction, do not set ISDN configuration definitions.

	Input Format
	[set]	default	-sdnppp			}]
		{-isdnppe					originate}]	]	Ver. 07-02
	[-isdn-{isdn-isdnppppppipremsurechominctiviallinddrssipaddanxceonnectablesucctraltim<Cunt>dirionmu<Byptyressnegoaddrpetryctiontti{bhrmeresstesgotiatiomes<Cout>ntrvalimsboth<Second>mde{assigncheck]h0h1}]<Cun>}]irectdisable<Minutes<Secoff]]on]]d>{]both
			{	r	orginateanswer]
4-48								GR2K-GA-0014