Hitachi GR2000 Series Setting of log syslog information, A notice level, Displaying Logger Co fi

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2

Example
1.	Setting of log syslog information
	The log of event level evt is set so that it is output to host name loghost as syslog
	of a notice level.
				gersyslogloghost notice evt
			showlogger
	(config)#
2.	logger{			syslog informa i						n
	Del tion of
	The setting f			r ou putting the						g of event level evt to host name loghost as syslog
	a notice evel is dele ed.
			delete					syslogloghostnoticeevt
					lologger
	Areyousure?(y/n)y
3.	Displaying				logger
				co fi		u ation informati
	To	how the syslog information.
	(config)#
	outputsysloglhostshowghostname, noticeevt;log information is outputted to the said host.
Re};atedsyslogConfiguratiloghostnoticen Object									evt;
Pre hostsautions
	The destinati				h st name must be predefi ed with the host object.
	In	der to use			he syslog setup function, the syslog daemon must be running on
	the destination host and such destination host must be so configured that it can
	rec	ve the sysl			inf		mation sent from this router.
	Do not define the same < v nt level> more than once in the same outbound
	dest nation				.
	Wh	IP address is defined to device itself by router-local_address, the IP address
	is used as the source address of syslog information.
	This functionsh			is capable of only outputting IPv4. Therefore, if the host name with
	logger;the IPv6 on y defined is specified with hosts (host name information) in the
	};If th	command is inputted in the cases where changes are made on the IP
	routing protocol information, the IP multicast protocol information, and the
￿	MPLS information, and the apply command is not being executed, the apply

subcommand is executed before the command is executed, and the changed IP routing protocol information, IP multicast routing protocol information, and MPLS information are reflected to the operation.

4-8	GR2K-GA-0014
	Ver. 07-02