Cisco Systems Cisco 7000, Cisco 7507 ,

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 15

Prerequisites

This section lists the tools you will need to complete this installation and the parts that are shipped

as part of the rack-mount kit. Ensure that you have all the tools and parts required so that you can

complete the installation without interruption.

Tools Required

You will need the following tools to install the mounting hardware and chassis in the rack:

•Number 2 Phillips screwdriver

•One 7/16-inch, open-end (or adjustable) wrench if you will remove the chassis feet

•Tape measure or level (both optional)

•Ohmmeter if your installation requires the chassis to be electrically isolated from the rack

You also need the following tools to replace the power supplies after mounting the chassis:

•A number 2 Phillips or 1/4-inch, ﬂat-blade screwdriver for the captive screw. (Because of

ongoing product improvements,some power supplies use slotted screws, and others use Phillips

screws.)

•If cables from other equipment fall in front of the powersupply bays, you will need cable ties to

temporarily anchor the cables out of the way while you install the power supplies.

Before beginning the power supply installation, check the captive installation screws on all power

supplies to determine which tools you will need.

Parts List

Table1 lists the parts that are included in the rack-mount kit. To verify that you received all the parts

listed, refer to Table1 and to Figure 2 on page 4.If any are missing, contact a service representative

for assistance. (Refer to the section “Cisco Information Online” at the end of this document.)

Table1 Rack-Mount Kit Parts Checklist

Note As you perform the installation, refer to Figure 2, on page 4, and to the detailed illustrations

that follow.

Quantity Part Description Received

2 Mounting brackets (left and right are identical), each with an attached spanner bar

2 Chassis ears with captive grommets (left and right ears are identical)

4 M4 x 10-mm LG Phillips ﬂat-head screws

10 10-32 x 5/8'' LG Phillips pan-head screws with integral square cone washers