Cisco Systems Cisco 7000, Cisco 7507 Positioning and Fastening a Spanner Bar

Installation

Figure 11 Positioning and Fastening a Spanner Bar

a

c

b

H2294

Caution To ensure adequate space between the brackets and a proper chassis fit, push the brackets as far apart as possible before tightening the screws that secure them and the spanner bars.

Step 5 When both spanner bars are in place, use a number 2 Phillips screwdriver to tighten the six pan-head screws that secure the brackets to the rack-mounting posts, and the two anchor screws that secure the spanner bars. When tightening the pan-head screws on a bracket, push the bracket outward, away from the center of the rack, to ensure that the brackets remain at least 17.5 inches apart (otherwise the chassis will not fit between the brackets).

This completes the bracket installation. To install the ears on the chassis, proceed to the next section.

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 19