57.Remove the 3/8” Nylon Jamnut (92) used in step 53. Route the Press Cable (72) through the Press Frame (17).
Wrap the Press Cable (72) around a 3 1/2” Pulley
(35)in the direction shown. Slide a Cable Trap
(38)and the Pulley onto the 3/8” x 4 3/4” Bolt
(102)in the bottom of the Press Upright (5). Properly tighten the 3/8” Nylon Jamnut (92) onto the Bolt. Make sure the Cable Trap is posi- tioned to hold the Cable in the groove of the Pulley.
58.Wrap the Press Cable (72) around a 3 1/2” Pulley
(35)in the direction shown. Slide a Cable Trap
(38)and the Pulley onto the 3/8” x 4” Carriage Bolt (112) in the Press Base (3). Secure the Pulley with a 3/8” Nylon Jamnut (92). Make sure the
Cable Trap is positioned to hold the Cable in the groove of the Pulley.
59.Lay the Press Cable (72) in the bracket on the Center Base (2). Attach a 3 1/2” Pulley (35) inside the bracket with a 3/8” x 1 3/4” Bolt (94) and a 3/8” Nylon Jamnut (92).
60.Wrap the Press Cable (72) around a 4 1/2” Pulley
(36)in the direction shown. Attach the Pulley inside the indicated bracket on the Center Top Frame (8) with a 3/8” x 1 3/4” Bolt (94) and a 3/8” Nylon Locknut (90).
57 |
|
|
|
|
|
|
|
| 38 |
|
|
|
| 72 |
| 5 | 102 | 35 | 92 |
| 17 |
|
| |
|
|
|
| |
58 |
|
|
|
|
| 72 | 92 |
|
|
|
| 35 |
| |
|
|
| 38 |
|
|
| 112 |
| |
|
| 3 |
|
|
59 |
|
|
|
|
72 | 35 | 94 |
| |
|
|
| ||
|
|
|
| |
|
|
| 92 |
|
|
|
| 2 |
|
60 |
| 72 |
|
|
8 | 90 |
|
| |
|
|
| ||
|
| 36 |
| |
|
|
|
| |
|
|
| 94 |
|
22
