Weider 831.159830 user manual Trap is positioned to hold the Cable in the, groove of the Pulley

29. Remove the 3 1/2” Pulleys (35) from a pair of pre-	29
assembled Pulley Plates (32).
Wrap the Rear Cable (70) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the top hole in the pair of
Pulley Plates (32) with a 3/8” x 2” Bolt (93) and a
3/8” Nylon Locknut (90). Make sure the Cable		70			93
Trap is positioned to hold the Cable in the
groove of the Pulley.				35	32
		90
		32	38
30. Wrap the Rear Cable (70) around a 4 1/2” Pulley	30
(36) in the direction shown. Attach the Pulley
	Bracket		90
inside the indicated bracket on the Center Top
Frame (8) with a 3/8” x 1 3/4” Bolt (94) and a 3/8”					36
Nylon Locknut (90).
					94
		8
				70
31. Attach the end of the Rear Cable (70) to a “U”-	31
Bracket (33) with a 1/4” Washer (99) and a 1/4”
Nylon Locknut (103).
Attach the “U”-Bracket (33) to the Short Weight				70
Tube (44) with a 5/16” x 1 3/4” Bolt (96) and a				96
5/16” Nylon Locknut (86).
		33
		86		99
				103
				44
32. Identify the Ab Cable (74). It is approximately	32
226 1/2” long, and it has a ball on one end and
an eyelet on the other.				Large tabs
	92	97
Wrap the Ab Cable (74) around a 3 1/2” Pulley				on this side
			39
(35) as shown. Place two Pulley Covers (39) over
the Pulley, so that the large tabs are on the side		Pin			39
shown. Attach the Pulley and Pulley Covers to the
Butterfly Upright (4) with a 3/8” x 3 3/4” Bolt		4			101
(101), two 3/8” Washers (97), and a 3/8” Nylon			35		97
Jamnut (92). Make sure the Cable is between				74
the Pulley and the pin on the Upright.

15