TP-Link TL-SG1016D/TL-SG1008 manual Product Installation, Desktop Installation, Rack Installation

Gigabit Unmanaged Switch

2222 Product Installation

■■ Desktop Installation

To install the device on the desktop, please follow the steps:

111Set the device on a flat surface strong enough to support the entire weight of the device with all fittings.

222Remove the adhesive backing papers from the rubber feet.

333Turnover the device and attach the supplied rubber feet to the recessed areas on the bottom at each corner of the device.

Feet

Bottom of the Device

Notch

FFFFFFFFFFF Desktop Installation

■■ Rack Installation

To install the device in an EIA standard-sized, 19-inch rack, follow the instructions described below:

111Check the grounding and stability of the rack.

222Secure the supplied rack-mounting brackets to each side of the device with supplied screws, as illustrated in the following figure.

Rack-mounting Bracket

Screw

FFFFFFFFFFF Bracket Installation

333After the brackets are attached to the device, use suitable screws (not provided\ to secure the brackets to the rack, as illustrated in the following figure.

Installation 08