72
Example
Enable the broadcast control function for port 5:
TL-SG2424(config)# interface gigabitEthernet 1/0/5
TL-SG2424(config-if)# storm-control broadcast
storm-control multicast
Description
The storm-control multicast command is used to enable the multicast control
function. To disable the multicast control function, please use no storm-control
multicast command. Multicast control function allows the switch to filter
multicast in the network. If the transmission rate of the multicast packets
exceeds the set bandwidth, the packets will be automatically discarded to avoid
network broadcast storm.
Syntax
storm-control multicast
no storm-control multicast
Parameter
rate —— Specify the bandwidth for receiving multicast packets on the port. The
packet traffic exceeding the bandwidth will be discarded. The value of it can be
128k | 256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps. By default,
the value is “128K”.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable the multicast control function for port 5:
TL-SG2424(config)# interface gigabitEthernet 1/0/5
TL-SG2424(config-if)# storm-control multicast
storm-control unicast
Description
The storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use no storm-control
unicast command. Unicast control function allows the switch to filter UL frame