16
Smart Switch
Ethernet Port21C
Please connect the Ethernet ports of the switch to the network devices by R J45 cable
as the following figure shown.
RJ45 Port
RJ45 Cable
Connecting the RJ45 PortFigure 4-1
SFP Port211
Connect the SFP port to a SFP module. For the switch, if an SFP trans ceiver (purchased
separately1 is installed in a slo t and has a valid link o n the port, the associated RJ45
port will be disabled and cannot be used.
SFP Port
Connecting the LAN PortFigure 4-2
Note:
SFP module supports hot-plugging, plug the SFP module into the SFP port and the
■
switch can identify it automatically.
The SFP port
■ suppor ts 100/1000 Base-FX SFP m odule at full-dup lex mod e. When
using a SFP m odule, yo u need to lo g on to the GUI of the switch a nd conf igure
the corresponding Speed and Duplex mode on Swi tching→Port→Port Config
page. Fo r 100M module, please select 100MFD w hile sel ect 1000 MFD for gigabit
module. By de fault, the Spe ed and Duple x mode of S FP mod e is 1000MFD. For
TL-SL2210/TL-SL2452, the SFP port can only be used with a gigabit module.
Connection
SFP Module