TP-Link TL-SL3428 manual CCCCCCCCCCCConnection, Ethernet Port, 4444SFP Port

L2 Managed Switch

CCCCCCCCCCCConnection

4444 Ethernet Port

Connect the Ethernet ports of the Switch to the network devices by RJ45 cable as the following figure shown.

RJ45 Port

RJ45 Cable

L2 Managed Switch

FFFFFFFFFFFFConnecting the RJ45 Port

4444SFP Port

Connect the SFP port to a SFP module. If an SFP transceiver (purchased separately\ is installed in a slot and has a valid link on the port, the associated RJ45 port will be

disabled and cannot be used.

TL-SL3428

L2 Managed Switch

SFP Port

SFP Module

FFFFFFFFFFFFInserting the SFP Module

Note:

The Switch supports 100/1000Base-FX SFP module at full-duplex mode. When using a SFP module, you need log on to the GUI of the Switch and configure the corresponding Speed and Duplex mode on Switching→Port→Port Config page.

13 Connection