TL-WA801ND 300Mbps Wireless N Access Point User Guide
) Note:
If the LAN port of TL-WA801ND is not connected to a switch but directly to a PC,
1. The PC can directly log on to the Web management page of TL-WA801ND and manage the
access point.
2. Only the wireless STA with its VLAN ID set to 1 can communicate with the wired PC.
3) Client: This mode allows the device to act as a wireless station to enable wired host(s) to
access an AP.
Figure 4-12 Wireless Settings in Client mode
¾ Enable WDS - The AP client can connect to AP with WDS enabled or disabled. If WDS is
enabled, all traffic from wired networks will be forwarded in the format of WDS frames
consisting of four address fields. If WDS is disabled, three address frames are used. If your
AP supports WDS well, please enable this option.
¾ Wireless Name of Root AP - If you select the radio button before Wireless Name of Root
AP, the AP client will connect to the AP according to SSID. Enter the SSID of AP that you
want to access.
¾ MAC Address of Root AP - If you select the radio button before MAC Address of Root AP,
the AP client will connect to the AP according MAC address. Enter the MAC address of AP
that you want to access.
¾ Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the device can be used. It may be illegal to use the wireless function of
the device in a region other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for assistance.
) Note:
Limited by local law regulations, version for North America does not have region selection
option.
30