Getting Started

System Information (sysinfo) Page

[Eth In] 55,256,030 bytes 24 Kbps [Eth Out] 3,348,202 bytes 3 Kbps [RF In] 1,377,125 bytes 0 Kbps [RF Out] 45,499,374 bytes 44 Kbps

[ARQ Retransmission] 881 pkts

Success.

#>

To view only a particular section of the sysinfo screen, type sysinfo followed by the desired section number.

Example:

#> sysinfo 2

********************************* 2 *********************************

[Radio Temp] 32 C [PoE Voltage] 14.2 V [Opmode] on [Default Opmode] on [Active Channel] 20 v [Freq] 5755 MHz

[Speed] 54 Mbps [Tx Power] 17 dBm [Power Range] -4..17 dBm [Peer ID] DE1B7747 [Status] connected [RSSI] -44 dBm [Peer IP Config] 10.8.2.139 255.255.255.224 10.8.2.129

Success.

Each of the parameters within the sysinfo screen is defined below

Section 0

 

[Model]

Radio Model # (P5010M)

[Unit Type]

User defined Unit Type (MU or RU)

[Hardware Version]

Hardware version set by factory (5010)

[Firmware Version]

Current firmware version loaded in radio

[System Up Time]

Time since last reboot or power cycle

Section 1

 

[MAC]

MAC address of radio

[S/N]

Serial Number of Radio

[IP]

User defined IP Address of radio

[Subnet Mask]

User entered IP Subnet Mask

[Gateway]

User entered IP address of the default router or gateway on the local

Section 2

Ethernet segment

 

[Radio Temp]

The internal temperature of the radio in Celsius

[POE Voltage]

The voltage the radio is receiving from the POE

[Opmode]

Operation mode of the radio: ON = transmitting, OFF= not transmitting

[Default Opmode]

Opmode which the radio defaults to after reboot.

[Active Channel]

Active RF Channel and Antenna polarization

[Freq]

Frequency of active channel

[Speed]

Modulation Speed (6,12,18,24,36, 54 Mbps)

[Tx Power]

Transmit Power

[Power Range]

Allowable power range for chosen Frequency (dBm)

[Peer ID]

MAC Address of remote radio

[Status]

Connection status of remote radio (connected or disconnected)

[RSSI]

Measured signal strength from remote radio (dBm)

[Peer IP Config]

Remote radio’s IP subnet, and default Gateway configuration

 

 

Trango Broadband Wireless — Atlas5010

page 14