Trango Broadband 5010 Remote Unit Configuration, Establishing a Wireless Link, sysinfo, #> freq 20, #> freq 20, #> sysinfo, #> opmode on Success, #> opmode on Success

Configuration Remote Unit Configuration

2.Set the Peer ID with the MAC address of the RU. Only use the last 8 digits of the MAC address.

#> peerid de1B7850 Success.

#>

3.Set channel and polarization. (in this example set the channel to 2 and polarization to H).

#> freq 20 v

Ch# 20 v (5775 MHz) Success.

4.Set default Opmode to ON.

#> defaultopmode on Success.

5.Turn Opmode ON.

#> opmode on Success.

.

Remote Unit Configuration

Configure the RU in the same manner as the MU. Since the default unit type (utype) is RU, you do not need to set this parameter.

1.Set the Peer ID with the MAC address of the MU. Only use the last 8 digits of the MAC address.

#> peerid de1B7842 Success.

#>

2.Set channel and polarization. (in this example set the channel to 2 and polarization to H).

#> freq 20 v

Ch# 20 v (5775 MHz) Success.

3.Set default Opmode to “ON.”

#> defaultopmode on Success.

4.Turn Opmode “ON.”

#> opmode on Success.

Establishing a Wireless Link

If the MU and RU are properly configured and in opmode “ON”, the two radios will automatically begin the authentication process and become connected. To determine if the two radios are connected, type the sysinfo 2 command.

Example:

#> sysinfo 2

********************************* 2 *********************************

[Radio Temp] 32 C [PoE Voltage] 14.2 V [Opmode] on [Default Opmode] on [Active Channel] 20 v [Freq] 5755 MHz

Trango Broadband Wireless — Atlas5010 page 17