MEDIA CONVERTER TECHNICAL SPECIFICATIONS
Standards | IEEE 802.3u |
|
Environment | Temperature: | |
| Humidity | |
| Altitude | |
Warranty | Five years |
|
Straight-through Cable Configuration
Minneapolis, MN 55344 USA
Slide-In-Module Media Converters
USER’S GUIDE
The TRANSITION Networks
Twisted Pair #1
Twisted Pair #2
Straight Through Cable
11
22
33
66
The two active pairs in a
FX multimode OR singlemode
C/E-100BTX-FRL-03
TX |
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in damage to the public telephone network.
Provides an
100BASE- |
P |
Fast Ethernet |
Multimode
Fiber
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den
Compliance Information
UL Listed
C/E-100BTX-FRL-03(SC)
Provides an
100BASE | ||
Copper | ||
|
P | |
100BASE | Multimode |
Fast Ethernet | Fiber |
| |
|
CISPR/EN55022 Class B
FCC Regulations
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
C/E-100BTX-FRL-03(SM)
Provides an
100BASE | ||
Copper | ||
|
P | |
100BASE | Singlemode |
Fast Ethernet | Fiber |
| |
| |
|
equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at the user’s own expense.
Canadian Regulations
This digital apparatus does not exceed the Class B limits for radio noise for digital apparatus set out on the radio interference regulations of the Canadian Department of Communications.
Copyright Restrictions
© 1998, 1999 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means – graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners. | 33044.C |
Status LEDs
100BA
P
Power Illuminated green LED indicates connection to external AC power.
SDF Signal Detect/Fiber: Steady green LED indicates fiber port is connected to device.
SDC Signal Detect/Copper: Steady green LED indicates
RXC Receive/Copper: Flashing green LED indicates packets are seen on
RXF Receive/Fiber: Flashing green LED indicates packets are seen on fiber port.