Installation
Copper and fiber ports
The illustration below shows the front panel of the
Installation -- Continued
Connect the fiber cable
Full duplex (always ON) is on the fiber side only; therefore, the
Front Panel
TP Link/Active
Fiber Link/Activity
TX RX
Fiber Port
Power ON LED
Copper Port
1.Locate or build IEEE 803.2™ compliant
2.Connect the fiber cable to the
•Connect the male TX cable connector to the female TX port.
•Connect the male RX cable connector to the female RX port.
3.Connect the fiber cable to the other device (another media converter, hub, etc.) as follows:
•Connect the male TX cable connector to the female RX port.
•Connect the male RX cable connector to the female TX port.
Electrostatic Discharge (ESD)
Always observe the following ESD precautions when installing or handing the
•Do not remove the converter from its protective packaging until you are ready to install it.
•Wear an ESD wrist grounding strap before handling any module or component. If you do not have a wrist strap, maintain grounded contact with the system unit
throughout any procedure requiring ESD protection.
Connect fiber cable | Connect fiber cable |
to media converter | to other device |
as shown. | (media converter, |
| hub, etc.) as shown |
RX | RX |
TX | TX |
Note: With AutoCross permanently enabled, the link LED only lights when a valid
2 | Tech Support: | techsupport@transition.com | 3 |