Manuals / Brands / Computer Equipment / Switch / Transition Networks / Computer Equipment / Switch

Transition Networks SMHB-TR-16 3.6 Resetting StackMasterTR 16-Port Stack

1 54

Download 54 pages, 355.22 Kb

3.6 Resetting StackMaster™TR 16-Port Stack

NOTE: The StackMaster™TR 16-Port Stack must be reset during

installation to initialize the internal software.

Managed Stack

•If the StackMaster™TR 16-Port Stack is managed, use a jewelers

screwdriver, paper clip, or other small device to depress the reset

switch inside the StackMaster™TR 16-Port Unit with SNMP

Management installed. The entire StackMaster™TR 16-Port Stack will

recycle and then resume normal operation.

Unmanaged Stack

•Reset the StackMaster™TR 16-Port units individually by using a

jewelers screwdriver, paper clip, or other small device to depress the

reset switch inside each StackMaster™TR 16-Port unit. The

StackMaster™TR 16-Port unit will recycle and then resume normal

operation. Other units in the StackMaster™TR 16-Port Stack will not

be affected.

33.. IINNSSTTAALLLLAATTIIOONN

3-7

USER’S GUIDE

Contents

Main CAUTION: Compliance Information FCC Regulations Canadian Regulations European Regulations Page Page Page Page 1. Introduction USERS GUIDE Connectors Ring In/Ring Out Connector Ring In R ing Out Lobe Connectors 1-2 StackMasterTR 11.. IINNTTRROODDUUCCTTIIOONN Power Connector Serial Mpls, MN 55344 Model#: SMHB-TR-16 Indicators Power LED Insert Normal 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 11.. IINNTTRROODDUUCCTTIIOONN USERS GUIDE Switches Active/Passive Switches Reset ZDL Switch Reset Switch 11.. IINNTTRROODDUUCCTTIIOONN USERS GUIDE Page 2. Site Planning 2.1 Site Considerations 2.2 Network Parameters Data Sheets TCP/IP Network Parameters Data Sheet SNMP Network Parameters Data Sheet 22.. SSIITTEE PPLLAANNNNIINNGG Serial Port Parameters Data Sheet 3. Installation 3.1 Unpacking StackMasterTR 16-Port Equipment 3.2 Stacking Units in Rack or on Table 3.2.1 Standard 19-Inch Rack Installation 3.2.2 Table-Top Installation 3.3 Cascading StackMasterTR Units 3.4 Connecting StackMasterTR to Token Ring Network 3.5 Connecting Units to Power 3.6 Resetting StackMasterTR 16-Port Stack Managed Stack Unmanaged Stack 3.7 Optionally Configuring SNMP Network Management at Attached Terminal Connecting to ASCII Terminal Bringing up Configuration Software. AT ANY AND ALL CONFIGURATION MENUS: Setting Network and SNMP Parameters Network Parameters SNMP Parameters Resetting the StackMasterTR 16-Port 4. Operation 4.1 Power On/Power Off Page 5. Maintenance 5.1 Fault Isolation Page USERS GUIDE 5.2 Recovery Procedures Managed Stack Unmanaged Stack USERS GUIDE 5.3 Replacement Procedures Replacing StackMasterTR 16-Port Unit Fuses 5.4 StackMasterTR 16-Port Field Upgrades 5.4.1 Installing SNMP Management Board Page Page USERS GUIDE 5.5 Software Upgrades 5.5.1 Software Upgrade at Attached ASCII Terminal Obtaining Updated StackMasterTR 16-Port Software Connecting to ASCII Terminal Page USERS GUIDE Resetting the StackMasterTR 16-Port Transferring the File Page Appendix A. Technical Specifications Page USER/S GUIDE Appendix B. Cable Specifications Page Appendix C. Cable Distance Page USER/S GUIDE Appendix D. Approved European Power Cord Set Page USER/S GUIDE