Transition Networks SMHB-TR-16

55.. MMAAIINNTTEENNAANNCCEE

USER’S GUIDE 5-7

NOTE: The internal fan is attached to the cover. Fan wires connect to the

attachedStackMaster™TR 16-Port circuit board.

5. Using necessary force, slide cover back to disengage from

chassis.

6. Without disconnecting fan wires, carefully lift the front of the

StackMaster™TR 16-Port Unit cover. Rotate the cover over

the StackMaster™TR 16-Port Unit until the cover rests

securely behind, and next to, the StackMaster™TR 16-Port

Unit.

7. Align the two snap-fit ends of the two SNMP Management

circuit board plastic spacers to the associated SNMP

Management circuit board holes.

8. Align the SNMP Management circuit board DIN connector

pins (male connector) to the StackMaster™TR 16-Port circuit

board DIN connector (female connector).

9. Apply downward pressure to the SNMP Management circuit

board until the SNMP Management circuit board DIN

connector is seated securely and the snap-fit connectors snap

into place.

Contents

Main CAUTION: Compliance Information FCC Regulations Canadian Regulations European Regulations Page Page Page Page 1. Introduction USERS GUIDE Connectors Ring In/Ring Out Connector Ring In R ing Out Lobe Connectors 1-2 StackMasterTR 11.. IINNTTRROODDUUCCTTIIOONN Power Connector Serial Mpls, MN 55344 Model#: SMHB-TR-16 Indicators Power LED Insert Normal 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 11.. IINNTTRROODDUUCCTTIIOONN USERS GUIDE Switches Active/Passive Switches Reset ZDL Switch Reset Switch 11.. IINNTTRROODDUUCCTTIIOONN USERS GUIDE Page 2. Site Planning 2.1 Site Considerations 2.2 Network Parameters Data Sheets TCP/IP Network Parameters Data Sheet SNMP Network Parameters Data Sheet 22.. SSIITTEE PPLLAANNNNIINNGG Serial Port Parameters Data Sheet 3. Installation 3.1 Unpacking StackMasterTR 16-Port Equipment 3.2 Stacking Units in Rack or on Table 3.2.1 Standard 19-Inch Rack Installation 3.2.2 Table-Top Installation 3.3 Cascading StackMasterTR Units 3.4 Connecting StackMasterTR to Token Ring Network 3.5 Connecting Units to Power 3.6 Resetting StackMasterTR 16-Port Stack Managed Stack Unmanaged Stack 3.7 Optionally Configuring SNMP Network Management at Attached Terminal Connecting to ASCII Terminal Bringing up Configuration Software. AT ANY AND ALL CONFIGURATION MENUS: Setting Network and SNMP Parameters Network Parameters SNMP Parameters Resetting the StackMasterTR 16-Port 4. Operation 4.1 Power On/Power Off Page 5. Maintenance 5.1 Fault Isolation Page USERS GUIDE 5.2 Recovery Procedures Managed Stack Unmanaged Stack USERS GUIDE 5.3 Replacement Procedures Replacing StackMasterTR 16-Port Unit Fuses 5.4 StackMasterTR 16-Port Field Upgrades 5.4.1 Installing SNMP Management Board Page Page USERS GUIDE 5.5 Software Upgrades 5.5.1 Software Upgrade at Attached ASCII Terminal Obtaining Updated StackMasterTR 16-Port Software Connecting to ASCII Terminal Page USERS GUIDE Resetting the StackMasterTR 16-Port Transferring the File Page Appendix A. Technical Specifications Page USER/S GUIDE Appendix B. Cable Specifications Page Appendix C. Cable Distance Page USER/S GUIDE Appendix D. Approved European Power Cord Set Page USER/S GUIDE