2. Use standard LAN cables to connect PCs to the Switching |
Hub ports on the Wireless Router. Both 10BaseT and |
oConfiguration
1.Start your PC. If it is already started, restart it.
It will then obtain an IP Address from the Wireless Router's DHCP Server.
2.Start your WEB browser. In the Address box, enter the following:
HTTP://192.168.1.1
3.The Setup Wizard will run automatically.
4.Step through the Wizard until finished. Refer to the data from your ISP, and the table below, to ensure your choices are correct.
Connection Type | Data required. |
Dynamic IP Address | Usually, none. |
| But some ISP may require a par- |
| ticular Hostname, Domain name, |
| or MAC (physical) address. |
| 100BaseT connections can be used simultaneously. |
3. | Connect your Cable/DSL Modem to the WAN port on |
| the Wireless Router. Use the cable supplied with your |
| DSL/Cable modem, or a standard network cable. |
4. | Connect the supplied Power Adapter and power on. |
5. | Check the LEDs |
Specified (Fixed)
IP Address
PPPoE
PPTP, Big Pond,
L2TP
IP Address allocated to you, and related information.
Login name and password.
Login name and password, Server Address
• The Status LED (Red) should flash, then turn OFF. If | |
| it stays on, there is a hardware error. |
• | The Power, WAN, and WLAN LEDs should be ON. |
• | For each active LAN (PC) connection, the LAN |
| Link/Act LED should be ON. |
5.On the final screen of the Wizard, run the test and check that an Internet connection can be established.
•If the connection fails, check both your data and the Cable/DSL modem.
•If your ISP has recorded your MAC (physical) address, change the MAC address (on the Wizard's Cable Mo- dem screen) to match the value expected by your ISP.
Page 2 | Page 3 |
