AES-100 User’s Guide

3.4.3Restart Command

Syntax:

restart

The restart command instructs the system to perform a warm start, i.e., restarting the system without turning the power on and off.

It is very important that you remember your password. If you forget it, refer to the Troubleshooting section

for help.

3.4.4Passwd Command

Syntax:

passwd

The passwd command changes the management password. The management password is used for authentication at console or telnet login. This command is only allowed for local console management sessions. The management password must be from 1 to 8 characters long and any character is accepted. The factory default password is “1234”.

3.4.5Config Print Command

Syntax:

config print

The config print command lists all current system configuration settings.

3.4.6Config Save Command

Syntax:

config save

The config save command saves all system configurations into nonvolatile memory. You must use this command to save any configurations that you make, otherwise the AES-100 will return to its default settings when it is restarted.

3.4.7Exit Command

Syntax:

exit

The exit command terminates the console or telnet mana gement session.

Software Configuration

3-3

Page 25
Image 25
ZyXEL Communications AES-100 Restart Command, Passwd Command, Config Print Command, Config Save Command, Exit Command