Process, used only in restoration | ZyXEL Communications AES-100

AES-100 User’s Guide

tftp> put initadsl

tftp> put resolve

tftp> put tftpupdt.end

where
tftplock.key =	The file that contains the SNMP write community string (password).
tftpupdt.beg =	An empty file (with no content). Marks the beginning of the restore
	process, used only in restoration.
initadsl =	The configuration file for ADSL ports.
resolve =	The configuration file for IP parameters.
tftpupdt.end =	An empty file (with no content). Marks the end of the restore process,
	used only in restoration.
Step 4. Quit TFTP.

tftp> quit

Wait for the update to finish and then restart the AES -100.

Configuration Backup/Restore

9-3

Image 55

ZyXEL Communications AES-100 manual Process, used only in restoration

Contents

AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Chapter Getting to Know the AES-100 Features Protocol MTU Application Benefits Scalable Platform for Future Expansion Physical SpecificationsISP Application Compact Design for Limited Space Dimensions Page Front Panel Additional Installation RequirementsChapter Hardware Overview Unpacking the AES-100 Front Panel Ports Console PortFront Panel LEDs Rear Panel Adsl Port Connections Connecting the Power Cord to the AES-100 and a Power Source Command Line Interface Chapter Software ConfigurationConsole Connection Version Command Command StructureSystem Commands Uptime Command Config Save Command Restart CommandPasswd Command Config Print CommandPage Adsl Standards Chapter Adsl ConfigurationConfigured Vs. Actual Speed Default Settings Disable Port Command Adsl CommandsDisable Ports Command Enable Ports Command Enable Port CommandLinedata Command Lineinfo Command Lineperf Command List Port Command Linerate Command Set Port Command List Ports CommandSet Ports Command Show Ports Command Show Port Command Status Command Mbps Ethernet Port ConfigurationEthernet Commands Set Duplex Command Mbps Ethernet Port Configuration Port-Based Vlan Chapter Bridge ConfigurationDefault Settings of Port-Based Vlan Bridge Port Numbers Filterage Command Bridge CommandsDevice Command Filter Command Portfilter Command Port-Based Vlan CommandsFlush Command Info Command Bridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Setting the IP Address Chapter IP Configuration Config Command General IP Commands Statistics Command Ping CommandPage Management by Telnet Chapter Remote ManagementSnmp Management Snmp Access Read/Write Command Snmp Access ConfigurationSupported MIBs Snmp Access List Command Snmp Trap ConfigurationSnmp Access Delete command Snmp Access Flush Command AES-100 User’s Guide Trap List Command Trap Add CommandTrap Delete Command Trap Flush CommandPage Configuration Files of the AES-100 Chapter Configuration Backup/RestoreControl Files Used In Tftp Operation Configuration Restore Configuration Backup Process, used only in restoration Page Chapter Firmware Upload BOOTP/TFTP Firmware Update of the AES-100 BOOTP/TFTP Server Input MAC Database Edit Dialog Transfer control files and firmware file to the AES-100 Tftp Firmware Update on the AES-100Page Adsl LEDs Chapter TroubleshootingData Transmission Adsl LEDs turn On and Off Configured SettingsData Rate Remote Server PasswordSnmp Telnet Troubleshooting Telnet Index Rear Panel Connections Terminal Emulation