Mbps Ethernet Port Configuration | ZyXEL Communications AES-100

AES-100 User’s Guide

Chapter 5 10 Mbps Ethernet Port Configuration

The Ethernet subsystem allows you to configure and monitor the 10 Mbps Ethernet port.

5.110 Mbps Ethernet

The AES-100 supports 10 Mbps Ethernet. In a 10 Mbps Ethernet, the duplex mode can be half duplex or full duplex.

The Ethernet port uses the pre-configured duplex mode setting when making a connection, thus requiring you to check the setting of the peer Ethernet port in order to connect.

5.2Default Settings

The factory default setting for the Ethernet port of the AES-100 is

-Half duplex

5.3Ethernet Commands

5.3.1Set Duplex Command

Syntax:

set duplex <mode>

where

<mode> = full or half

The set duplex command sets the duplex mode used.

5.3.2Status Command

Syntax:

status

The status command shows the current status of the Ethernet port.

10 Mbps Ethernet Port Configuration

5-1

Image 35

ZyXEL Communications AES-100 manual Mbps Ethernet Port Configuration, Ethernet Commands, Set Duplex Command, Status Command

Contents

AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Chapter Getting to Know the AES-100 Features Protocol MTU Application Benefits Scalable Platform for Future Expansion Physical SpecificationsISP Application Compact Design for Limited Space Dimensions Page Front Panel Additional Installation RequirementsChapter Hardware Overview Unpacking the AES-100 Front Panel LEDs Console PortFront Panel Ports Rear Panel Adsl Port Connections Connecting the Power Cord to the AES-100 and a Power Source Console Connection Chapter Software ConfigurationCommand Line Interface Version Command Command StructureSystem Commands Uptime Command Config Save Command Restart CommandPasswd Command Config Print CommandPage Adsl Standards Chapter Adsl ConfigurationConfigured Vs. Actual Speed Default Settings Disable Ports Command Adsl CommandsDisable Port Command Linedata Command Enable Port CommandEnable Ports Command Lineinfo Command Lineperf Command List Port Command Linerate Command Set Ports Command List Ports CommandSet Port Command Show Ports Command Show Port Command Status Command Mbps Ethernet Port ConfigurationEthernet Commands Set Duplex Command Mbps Ethernet Port Configuration Port-Based Vlan Chapter Bridge ConfigurationDefault Settings of Port-Based Vlan Bridge Port Numbers Filterage Command Bridge CommandsDevice Command Filter Command Portfilter Command Port-Based Vlan CommandsFlush Command Info Command Bridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Setting the IP Address Chapter IP Configuration Config Command General IP Commands Statistics Command Ping CommandPage Snmp Management Chapter Remote ManagementManagement by Telnet Supported MIBs Snmp Access ConfigurationSnmp Access Read/Write Command Snmp Access List Command Snmp Trap ConfigurationSnmp Access Delete command Snmp Access Flush Command AES-100 User’s Guide Trap List Command Trap Add CommandTrap Delete Command Trap Flush CommandPage Control Files Used In Tftp Operation Chapter Configuration Backup/RestoreConfiguration Files of the AES-100 Configuration Restore Configuration Backup Process, used only in restoration Page Chapter Firmware Upload BOOTP/TFTP Firmware Update of the AES-100 BOOTP/TFTP Server Input MAC Database Edit Dialog Transfer control files and firmware file to the AES-100 Tftp Firmware Update on the AES-100Page Data Transmission Chapter TroubleshootingAdsl LEDs Data Rate Configured SettingsAdsl LEDs turn On and Off Snmp PasswordRemote Server Telnet Troubleshooting Telnet Index Rear Panel Connections Terminal Emulation