ZyXEL Communications AES-100 manual Troubleshooting Telnet

AES-100 User’s Guide

11.9Telnet

I can not telnet into the AES-100.

	Table 11-9 Troubleshooting Telnet
STEPS	CORRECTIVE ACTION
1	Make sure that a telnet session is not already operating. The AES-100 will only accept one telnet session at
	a time.
2	Ping the AES-100 from your computer.
	If you are able to ping the AES-100 but are still unable to telnet, contact the distributor.
	If you cannot ping the AES-100, check the IP addresses in the AES-100 and your computer. Make sure that
	both IP addresses are located in the same subnet (refer to the Setting IP Address section of this User’s
	Guide).
3	If you are attempting to telnet from the ADSL side of the AES-100, refer to Data Transmission in this chapter
	to make sure that you can transmit data to the AES-100.
4	If you are attempting to telnet from the Ethernet side of the AES-100, check the Ethernet cable.
5	Make sure that the device type of the AES-100’s IP address is set to bridge (refer to the Setting IP Address
	section).
	If these steps fail to correct the problem, contact the distributor.

11-4 Troubleshooting