ZyXEL Communications AES-100 Snmp Trap Configuration, Snmp Access Delete command, Supported Traps

AES-100 User’s Guide

access <read write> <community> [<IP addr>]

where

<read write> = <community> = [<IP addr>] =

Specifies read-only/read-write permission.

Password needed to access the SNMP agent on the AES-100.

Optional IP address of the allowed SNMP manager.

This command allows read-only or read-write access. If the IP address is specified, access is allowed for the manager station with that address only.

8.3.2SNMP Access Delete command

Syntax:

access delete <community> [<IP addr>]

This command revokes SNMP access by the specified community (password). If the IP address is specified, access is denied for that manager station only.

8.3.3SNMP Access Flush Command

Syntax:

access flush

This command revokes access by any and all manager stations.

8.3.4SNMP Access List Command

Syntax:

access list

This command shows the allowed access.

8.4SNMP Trap Configuration

The AES-100 uses the SNMP trapping facility to proactively report unusual events to one or more trap servers. To configure the trap parameters, use the trap commands in the SNMP subsystem. After configuring the SNMP trap parameters, save the configuration to the nonvolatile memory with the config save command.

8.4.1Supported Traps

AES-100 supports the following traps

Remote Management 8-3