Database Edit Dialog | ZyXEL Communications AES-100 manual

AES-100 User’s Guide

Figure 10-3 Database Edit Dialog

Step 8. Choose Normal Bootp to enable normal BOOTP/TFTP functions.

Figure 10-4 Enable BOOTP/TFTP

Step 9. Restart the AES-100 and press any key within three seconds to get the following console window:

SDRAM Testing . . .

AES-100 Boot Loader, Feb 7 2001 12:06:03

Copyright © 2001 ZyXEL Communications Corp.

Mac address 00:A0:C5:12:34:56

Figure 10-5 Enter Debug Mode

Step 10. Enter atnb at the AES-100 boot console.

Step 11. Wait for the firmware upload to finish.

Step 12. Use the following command sequence on the AES-100 to write new firmware to flash memory.

-192.168.1.1> flashfs

-192.168.1.1 flashfs> wipe

-192.168.1.1 flashfs> update

Wait for the update to complete and then restart the AES-100.

10-4	Firmware Upload

Image 60

ZyXEL Communications AES-100 manual Database Edit Dialog

Contents

AES-100 Copyright ZyXEL Limited Warranty Interference Statements and Warnings Customer Support Table of Contents Table of Contents Vii Viii Table of Contents List of Figures 11-4 Preface Features Chapter Getting to Know the AES-100 Protocol Benefits MTU Application Physical Specifications ISP ApplicationCompact Design for Limited Space Scalable Platform for Future Expansion Dimensions Page Additional Installation Requirements Chapter Hardware OverviewUnpacking the AES-100 Front Panel Console Port Front Panel PortsFront Panel LEDs Adsl Port Connections Rear Panel Connecting the Power Cord to the AES-100 and a Power Source Chapter Software Configuration Command Line InterfaceConsole Connection Command Structure System CommandsUptime Command Version Command Restart Command Passwd CommandConfig Print Command Config Save CommandPage Chapter Adsl Configuration Configured Vs. Actual SpeedDefault Settings Adsl Standards Adsl Commands Disable Port CommandDisable Ports Command Enable Port Command Enable Ports CommandLinedata Command Lineinfo Command Lineperf Command Linerate Command List Port Command List Ports Command Set Port CommandSet Ports Command Show Port Command Show Ports Command Mbps Ethernet Port Configuration Ethernet CommandsSet Duplex Command Status Command Mbps Ethernet Port Configuration Chapter Bridge Configuration Default Settings of Port-Based VlanBridge Port Numbers Port-Based Vlan Bridge Commands Device CommandFilter Command Filterage Command Port-Based Vlan Commands Flush CommandInfo Command Portfilter Command Bridge Bridge portfilter 2 1 Bridge portfilter 3 1 Example of Modified Vlan Port Example of Modified Vlan Settings Chapter IP Configuration Setting the IP Address General IP Commands Config Command Ping Command Statistics CommandPage Chapter Remote Management Management by TelnetSnmp Management Snmp Access Configuration Snmp Access Read/Write CommandSupported MIBs Snmp Trap Configuration Snmp Access Delete commandSnmp Access Flush Command Snmp Access List Command AES-100 User’s Guide Trap Add Command Trap Delete CommandTrap Flush Command Trap List CommandPage Chapter Configuration Backup/Restore Configuration Files of the AES-100Control Files Used In Tftp Operation Configuration Backup Configuration Restore Process, used only in restoration Page BOOTP/TFTP Firmware Update of the AES-100 Chapter Firmware Upload BOOTP/TFTP Server Input MAC Database Edit Dialog Tftp Firmware Update on the AES-100 Transfer control files and firmware file to the AES-100Page Chapter Troubleshooting Adsl LEDsData Transmission Configured Settings Adsl LEDs turn On and OffData Rate Password Remote ServerSnmp Troubleshooting Telnet Telnet Index Rear Panel Connections Terminal Emulation