TRENDnet 4-Port Powerline 500 AV Adapter, TPL-4052E Using the Powerline Ulity

TPL-4052E User’s Guide Securing Your Powerline Network

Conguring an addional Powerline Adapter to connect and

use the network name of your exisng powerline network:

Note: Use the Sync buon procedure below if you are connecng

TRENDnet Powerline models TPL-401E, TPL-402E, TPL-405E , TPL-406E ,

TPL-407E or TPL-4052E.

1� Verify that all exisng Powerline Adapters are already installed and

connected�

Prepare your adapter:

2� Push and hold the Sync buon on the addional Powerline Adapter

for 15 seconds and then release it. All LEDs will turn o and turn

back on. This will erase the current network name assigned to the

addional Powerline Adapter.

Start associaon:

3� Push and hold the Sync buon on one of the exisng Powerline

Adapters connected to your powerline network for 2 seconds and

then release it. The Power (PWR) LED will start blinking.

4� Within 2 minutes, push and hold the Sync buon on the addional

Powerline Adapter for 2 seconds and release it. The Power

(PWR) LED will start blinking. This will recongure your addional

Powerline Adapter to connect and use the network name of your

exisng powerline network. All LEDs will turn o and turn back on

and the Powerline (PL) LED will turn on the adapters are connected.

Congure to add addional Powerline Adapters to your exisng

powerline network, repeat the steps above for each adapter.

Using the Powerline Ulity

The Powerline Ulity allows you doing following jobs:

1� Create a customized network name for your powerline network

and apply it to mulple Powerline Adapters at the same me.

2� View Powerline Adapters connected to your network (using

the MAC address) and the approximate connecon quality and

speed of each Powerline Adapter.

3� View and upgrade Powerline Adapter rmware.

Note: Link speed displayed in the ulity of your Powerline

Adapters to another through your electrical system is esmated.

Actual link speed may vary.

Beforeinstallingandusingtheulity,pleaseensurethefollowing:

1. Write down the DevicePassword(DPW) (16-digit characters

A-Z only) and MAC Address (12-digit characters a-f, A-F, 0-9) of

each Powerline Adapter as this will be required to change the

network name for mulple Powerline Adapters. See “Product

informaon on device label” on page 2.

2. Make sure your computer in which you are installing the ulity

is connected to your network and your Powerline Adapters are

also connected to your network.

3. If you have changed your network name using the Sync buon

and you are creang a customized network name, it is required

to reset all powerline devices to factory defaults using the

physical Reset buon on your Powerline Adapter before using

the ulity. See”Push Buons” on page 3.

4. Please ensure that your Powerline Adapters are already

installed and connected and the Ethernet port on each adapter

is connected to a device powered on.