TPL-4052E User’s Guide Declaration of Conformity
© Copyright 2013 TRENDnet. All rights reserved. 25
Federal Communicaon Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against harmful interference in
a residenal installaon. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules. Operaon is subject to the
following two condions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operaon.
IMPORTANT NOTE:
FCC Radiaon Exposure Statement:
This equipment complies with FCC radiaon exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This transmier must not be co-located or operang in conjuncon with any
other antenna or transmier.
The availability of some specic channels and/or operaonal frequency bands
are country dependent and are rmware programmed at the factory to match
the intended desnaon. The rmware seng is not accessible by the end
user�
RoHS
This product is RoHS compliant.
Europe – EU Declaraon of Conformity
This device complies with the essenal requirements of the Direcve
2004/108/EC, /2006/95/EC and 2009/125/EC:
EN55022 : 2010, class B
EN 61000-6-3 : 2007 + A1 :2011
EN 61000-3-2 : 20086 + A1 : 2009 + A2 : 2009,
class A
EN 61000-3-3 : 2008
EN 50412-2-1 :2005, class 1, type 2
EN 60950-1 :2006 + A11 : 2009 + A1 : 2010 + A2 : 2011 : Safety of Informaon Technology Equipment
including electrical business equipment