TRENDnet TRENDNET, TEW-637AP manual LED/Button

5.I followed the Quick Installation Guide and setup a new password. When I log in to the browser configuration an access error message appears. What should I do?

If the password was changed and you don't remember it, you need to reset the TEW-637AP. To reset the TEW-637AP, power up the unit and wait 30 seconds for the unit to boot up. Then take a pin or paper clip and press the reset button for 15 seconds, then let go. The reset button is located on the bottom of the TEW-637AP. Please note that performing a reset on the TEW-637AP will erase all settings applied and will revert back to default settings. The default user name is admin and the default password is admin. When you log in to the browser configuration for the first time, make sure to enter admin for user name. Do not leave the user name field blank

LED/Button	Color	Sequence	Definition
PWR (Power) LED	Green	Solid	Device is on
	N/A	Off	Device is off
		Solid	LAN port connected at 10/20 Mbps or 100/200Mbps
Network Port	Green		(Half/Full Duplex)
Link/Act LEDs		Blinking	LAN port data transmitting/receiving 10/20Mbps
			or 100/200Mbps (Half/Full Duplex)
	N/A	Off	Wireless LAN is on or enabled/Wireless data transmission
Wireless LED	Green	Blinking	Wireless LAN is on or enabled/Wireless data transmission
	N/A	Off	Wireless LAN is off or disabled
	Green	Solid	WPS authentication process complete
WPS LED		Blinking	WPS authentication in process
	N/A	Off	WPS is not activated or disabled
Power Switch	N/A	N/A	Turns on/off power to the TEW-637AP
(EU Version only)
Reset Button	N/A	N/A	Hold 15 seconds to reset device to factory defaults.
WPS Button	N/A	N/A	Hold 3 seconds to activate WPS

If you still encounter problems or have any questions regarding the TEW-637AP,please contact TRENDnet's Technical Support Department.

8