OPERATING INSTRUCTIONS - Using Your Ultrasonic Humidifier and Night Lamp
A. First Time Use
Read all instructions before using Humio.
Please unpack and remove all protective packing material from the water tank, mist nozzle and motor base. Completely unravel the power cord and set Humio on a flat, stable surface. Follow the directions below.
Filling the Water Tank Using Water from a Faucet
1.Always make sure the unit is turned off before removing the Water Tank. As an added safety precaution, unplug Humio before removing and filling the Water Tank.
2.Remove the Water Tank from the Motor Base by grasping the removable Neck Handle.
3.With one hand, firmly grasp the Neck Handle and turn the Water Tank upside down. With your free hand firmly grasp the Water Tank Cap and turn counterclockwise to open.
4.Hold the Water Tank under the faucet and fill with cool clean tap water. If you cannot fit the water tank under the faucet with the Neck Handle on, please stop and remove the Neck Handle by turning counterclockwise. Replace the Neck Handle by firmly turning clockwise after you have filled the water tank. Neck Ring may be removed but must be replaced.
5.Replace the Water Tank Cap by firmly turning clockwise.
6.Turn the Water Tank upright and check the Water Tank Cap for leaks. If any water drips from
the Water Tank Cap, remove the water tank cap and
7.Replace the water tank on the base by aligning the positioning points in the center to meet one another.
8.Wipe the Water Tank with a dry cloth to remove excess water drops.
Please note, when using water from the faucet, minerals normally present in hard tap water increase the development of crusty deposits known as scale which may be dispersed into the air and may appear as “white dust” on surfaces. In order to reduce the growth of scale and white dust, using dis- tilled water is recommended. Please also see Proper Care Cleaning and Maintenance section of this manual.
Filling the Water Tank Using Water from a Water Bottle
1.Always make sure the unit is turned off before removing the Water Tank. As an added safety pre- caution, unplug Humio before removing and filling the Water Tank.
2.Remove the Water Tank from the Motor Base by grasping the removable Neck Handle.
3.With one hand, firmly grasp the Neck Handle and turn the Water Tank upside down. With your free hand firmly grasp the Water Tank Cap and turn counterclockwise to open.
4.Grasp the motor base firmly and remove the neck handle by twisting the neck handle counter- clockwise. Neck ring may be removed but must be replaced.
5.Set the water tank upside down on a flat, stable
6.Fill the water tank with cool clean water.
7.Replace the water tank cap by firmly turning clockwise.
8.Set neck ring in place and replace the neck handle by firmly turning clockwise.
6
